Refer to the exhibit.

Refer to the exhibit. An engineer configures HSRP and enters the show standby command. Which two facts about the network environment are derived from the output? (Choose two.)

• A.The local device has a higher priority selling than the active router
• B.The virtual IP address of the HSRP group is 10.1.1.1.
• C.The hello and hold timers are set to custom values.
• D.If the local device fails to receive a hello from the active router for more than 5 seconds, it becomes the active router.
• E.If a router with a higher IP address and same HSRP priority as the active router becomes available, that router becomes the new active router 5 seconds later.

Comment: *

Name: *

Email: *

Verification: *

How is a data modeling language used?

• A.To enable data lo be easily structured, grouped, validated, and replicated
• B.To represent finite and well-defined network elements that cannot be changed
• C.To provide human readability to scripting languages
• D.To model the flows of unstructured data within the infrastructure

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer must set up connectivity between a campus aggregation layer and a branch office access layer.
The engineer uses dynamic trunking protocol to establish this connection, however, management traffic on VLAN1 is not passing. Which action resolves the issue and allow communication for all configured VLANs?

• A.Disable Spanning Tree for the native VLAN.
• B.Change both interfaces to access ports.
• C.Configure the correct native VLAN on the remote interface
• D.Allow all VLANs on the trunk links

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

SwitchC connects HR and Sales to the Core switch. However, business needs require that no traffic from the Finance VLAN traverse this switch.
Which command meets this requirement?

• A.SwitchC(config)#vtp pruning
• B.SwitchC(config)#interface port-channel 1
  SwitchC(config-if)#switchport trunk allowed vlan add 210,310
• C.SwitchC(config)#vtp pruning vlan 110
• D.SwitchC(config)#interface port-channel 1
  SwitchC(config-if)#switchport trunk allowed vlan remove 110

Comment: *

Name: *

Email: *

Verification: *

What is the function of the fabric control plane node In a Cisco SD-Access deployment?

• A.It is responsible for policy application and network segmentation in the fabric.
• B.It performs traffic encapsulation and security profiles enforcement in the fabric.
• C.It holds a comprehensive database that tracks endpoints and networks in the fabric.
• D.It provides Integration with legacy nonfabric-enabled environments.

Comment: *

Name: *

Email: *

Verification: *