Drag and drop the characteristics from the left onto the deployment types on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2.

Based on the output from SW1 and the log message received on Switch SW2, what action should the engineer take to resolve this issue?

• A.Configure the same protocol on the EtherChannel on switch SW1 and SW2.
• B.Connect the configuration error on interface Gi0/1 on switch SW1.
• C.Define the correct port members on the EtherChannel on switch SW1.
• D.Correct the configuration error on interface Gi0/0 switch SW1.

Comment: *

Name: *

Email: *

Verification: *

A network engineer is adding an additional 10Gps link to an exiting 2x10Gps LACP-based LAG to augment its capacity. Network standards require a bundle interface to be taken out of service if one of its member links goes down, and the new link must be added with minimal impact to the production network. Drag and drop the tasks that the engineer must perform from the left into the sequence on the right. Not all options are used.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

A customer has several small branches and wants to deploy a WI-FI solution with local management using CAPWAP. Which deployment model meets this requirement?

• A.Autonomous
• B.Mobility Express
• C.SD-Access wireless
• D.Local mode

Comment: *

Name: *

Email: *

Verification: *

What is the result of applying this access control list?

• A.TCP traffic with the URG bit set is allowed
• B.TCP traffic with the SYN bit set is allowed
• C.TCP traffic with the ACK bit set is allowed
• D.TCP traffic with the DF bit set is allowed

Correct Answer: C

Explanation
The established keyword is only applicable to TCP access list entries to match TCP segments that have the ACK and/or RST control bit set (regardless of the source and destination ports), which assumes that a TCP connection has already been established in one direction only. Let's see an example below:

Suppose you only want to allow the hosts inside your company to telnet to an outside server but not vice versa, you can simply use an "established" access-list like this: access-list 100 permit tcp any any established access-list 101 permit tcp any any eq telnet ! interface S0/0 ip access-group 100 in ip access-group 101 out

Comment: *

Name: *

Email: *

Verification: *