While configuring an IOS router for HSRP with a virtual IP of 10 1.1.1. an engineer sees this log message.

Which configuration change must the engineer make?

• A.Change the HSRP group configuration on the local router to 1.
• B.Change the HSRP group configuration on the remote router to 1.
• C.Change the HSRP virtual address on the local router to 10.1.1.1.
• D.Change the HSRP virtual address on the remote router to 10.1.1.1.

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the threat defense solutions from the left onto their descriptions on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

An engineer has deployed a single Cisco 5520 WLC with a management IP address of 172.16.50.5/24. The engineer must register 50 new Cisco AIR-CAP2802I-E-K9 access points to the WLC using DHCP option 43. The access points are connected to a switch in VLAN 100 that uses the 172.16.100.0/24 subnet. The engineer has configured the DHCP scope on the switch as follows:

The access points are failing to join the wireless LAN controller. Which action resolves the issue?

• A.configure dns-server 172.16.100.1
• B.configure dns-server 172.16.50.5
• C.configure option 43 Hex F104.AC10.3205
• D.configure option 43 Hex F104.CA10.3205

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What step resolves the authentication issue?

• A.use basic authentication
• B.target 192 168 100 82 in the URI
• C.change the port to 12446
• D.restart the vsmart host

Comment: *

Name: *

Email: *

Verification: *

How does SSO work with HSRP to minimize network disruptions?

• A.It enables HSRP to elect another switch in the group as the active HSRP switch.
• B.It ensures fast failover in the case of link failure.
• C.It enables data forwarding along known routes following a switchover, white the routing protocol reconverges.
• D.It enables HSRP to failover to the standby RP on the same device.

Comment: *

Name: *

Email: *

Verification: *