An engineer is configuring GigabitEthernet1/0/0 for VRRP. When the router has the highest priority in group 5, it must assume the master role.
Which command set should the engineer add to the configuration to accomplish this task?
interface GigabitEthernet1/0/0
description To IDF A 38-70-774-10
ip address 172.16.13.2 255.255.255.0

• A.standby 5 ip 172.16.13.254
  standby 5 priority 100
  standby 5 preempt
• B.vrrp 5 ip 172.16.13.254 255.255.255.0
  vrrp 5 track 1 decrement 10
  vrrp 5 preempt
• C.vrrp 5 ip 172.16.13.254
  vrrp 5 priority 100
• D.standby 5 ip 172.16.13.254
  standby 5 priority 100
  standby 5 track 1 decrement 10

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The connection between SW1 and SW2 is not operational. Which two actions resolve the issue? (Choose two.)

• A.configure switchport mode access on SW2
• B.configure switchport nonegotiate on SW2
• C.configure switchport mode trunk on SW2
• D.configure switchport mode dynamic desirable on SW2
• E.configure no switchport nonegotiate on SW1

Correct Answer: D,E

Explanation
From the outputs (line: "Administrative Mode: dynamic auto") we notice that both interfaces were configured with "dynamic auto" mode so they cannot form a trunking link. We need to change one of them to "dynamic desirable" mode to activate the trunk -> Answer D is correct.
Another problem is SW1 was set to "nonegotiate" (from the line: "Negotiation of Trunking: Off") which prevents DTP negotiation packets from being sent out the interface. We need to re-enable with the "no switchport nonegotiate" command -> Answer E is correct.
For your reference, the table below lists trunking condition:

DTP_modes.png

Comment: *

Name: *

Email: *

Verification: *

Which protocol does REST API rely on to secure the communication channel?

• A.HTTPS
• B.SSH
• C.HTTP
• D.TCP

Comment: *

Name: *

Email: *

Verification: *

Which PAgP mode combination prevents an Etherchannel from forming?

• A.auto/auto
• B.desirable/desirable
• C.auto/desirable
• D.desirable

Correct Answer: A

There are two PAgP modes:

The table below lists if an EtherChannel will be formed or not for PAgP:

Comment: *

Name: *

Email: *

Verification: *

Company policy restricts VLAN 10 to be allowed only on SW1 and SW2. All other VLANs can be on all three switches. An administrator has noticed that VLAN 10 has propagated to SW3. Which configuration corrects the issue?
A)

B)

C)

D)

• A.Option D
• B.Option C
• C.Option A
• D.Option B

Comment: *

Name: *

Email: *

Verification: *