Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

• A.In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
• B.OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0
• C.OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
• D.IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit:

You are configuring an administrative domain implement so that devices can dynamically learn the RP?

• A.SSM
• B.Auto-RP
• C.BID1R-PIM
• D.BSR

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer has started to configure a router for secure remote access as shown. All users who require network access need to be authenticated by the SSH Protocol.Which two actions must the engineer implement to complete the SSH configuration? (Choose two.)

• A.Configure an IP domain name.
• B.Configure service password encryption.
• C.Configure crypto keys
• D.Configure a password under the vty lines.
• E.Configure ACL 100 to permit access to port 22.

Comment: *

Name: *

Email: *

Verification: *

You are testing the capabilities of MPLS OAM ping. Which statement is true?

• A.An LSP is not required for the reply to reach the ingress MPLS router.
• B.An LSP breakage results in the ingress MPLS router never receiving any reply.
• C.MPLS OAM ping works solely with P2P LSPs.
• D.MPLS OAM ping works solely with Cisco MPLS TE.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer has started to configure a router for OSPF, as shown Which configuration must an engineer apply on the network so that area 15 traffic from R5 to R1 will prefer the route through R4?

• A.Place the link between R3 and R5 in a stub area to force traffic to use the route through R4.
• B.Increase the cost on the link between R2 and R4, to influence the path over R3 and R4.
• C.Implement a multiarea adjacency on the link between R2 and R4, with the cost manipulated to make the path through R4 preferred.
• D.Implement a sham link on the between R3 and R2 to extend area 0 area 15.

Comment: *

Name: *

Email: *

Verification: *