An engineer must implement QoS to prioritize traffic that requires better service throughout the network. The engineer started by configuring a class map to identify the high-priority traffic. Which additional tasks must the engineer perform to implement the new QoS policy?

• A.Attach the class map to a policy map that designates the action to be taken on the classified traffic and then attach the policy map to an interface using a service policy.
• B.Attach the class map to a policy map within a VRF to segregate the high-priority traffic and then attach the policy map to an interface in another VRF.
• C.Attach the class map to a policy map that sets the minimum bandwidth allocated to the classified traffic and designates the action to be taken on the traffic.
• D.Create a route map to manipulate the routes that are entered into the routing table and then attach the route map to an interface using a service policy.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer wants to monitor traffic from the application server and send the output to the external monitoring device at 172.16.20.5. Application server traffic should pass through the R1 Eth2/1 interface for further analysis after it is monitored. Which configuration must be applied on the R1 router?

• A.Configure the ip flow monitor FLOW-MONITOR-10 output command on the Ethernet 2/1 interface.
• B.Configure the FLOW-MONITOR-20 command.
• C.Configure the ip flow monitor FLOW-MONITOR-10 input command on the Ethernet1/0 interface.
• D.Configure the flow exporter EXPORTER-10 destination 192.168.20.4 command.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer must deny access from spoofed addresses to the LAN.
The edge router currently has two active BGP sessions established with Tier 1 ISP_A. Due to asymmetric routing, no ACL is configured on either interface. Which two configurations must the engineer perform on the edge router to complete the task? (Choose two.)

• A.ip verify unicast source reachable-via under FA0/1
• B.ip verify unicast source reachable-via tx under FA0/0
• C.ip verify unicast source reachable-via any under FA0/1
• D.ip verify unicast source reachable-via any under FA0/0
• E.ip verify unicast source reachable-via both under FA0/0

Comment: *

Name: *

Email: *

Verification: *

Which two actions describe ISP delegation to PCE servers? (Choose two)

• A.removing TE re-optimization timer timeouts
• B.adding a new PCE server with higher precedence than the primary PCE
• C.entering the mpls traffic-eng reoptimize command
• D.adding a new PCE server with lower precedence than the primary PCE
• E.changing the precedence of any of the PCE servers

Comment: *

Name: *

Email: *

Verification: *

Refer to the exihibit.

Refer to the exhibit. Router 1 and Router 2 were installed in the data center. Router 1 is the core router in the network, but it fails to establish an OSPF peering with Router 2. and customer traffic is unable to pass. Router 1 also reports an increase in CPU and memory usage. However, the CPU for R2 is stable. Which action resolves this issue?

• A.Disable Cisco Express Forwarding on Router 2.
• B.Change the transport mode to WAN on Router 1.
• C.Change the MTU to 1524 on Router 1.
• D.Enable MPLS on Router 2.

Comment: *

Name: *

Email: *

Verification: *