Free Access to Cisco.350-501.v2025-11-05.q511 with Valid Practice Test (Page 76)

Home
Cisco Certification
350-501 Exam
Cisco.350-501.v2025-11-05.q511 Dumps

Question 371

Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

A.OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
B.In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
C.OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0
D.IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway

Question 372

Simulation1
Refer to the exhibit.

Question 373

Refer to the exihibit.

Refer to the exhibit. Customer_A asked ISP_A to connect two offices via an MPLS L3 VPN. Customer_A is currently using only the default route toward ISP_A.
The engineer at ISP_A already configured the ip route vrf Customer_A 172.16.10.0 255.255.255.0 10.10.10.1 command on R1. Which action completes the configuration?

A.Configure the network 172.16.10.0 and redistribute-internal static commands under the BGP address family for Customer_A in the global BGP configuration on R1.
B.Enable the bgp default route-target filter and default-Information originate commands under the global BGP configuration on R2.
C.Configure the route-target both 200:1 and route-replicate vrf Customer_A commands under the lp vrf configuration on R2.
D.Configure the redistribute static and redistribute connected commands on R1.