Refer to the exhibit.

Refer to the exhibit. The application server in the data center hosts voice, video, and data applications over the internet. The data applications run more slowly than the voice and video applications. To ensure that all applications run smoothly, the service provider decided to implement a QoS policy on router PER 2 to apply traffic shaping. Which two actions must an engineer take to implement the task? (Choose two.)

• A.Set the token value for secondary traffic.
• B.Configure the scheduling function to handle delayed packets.
• C.Configure a queue to buffer excess traffic.
• D.Set a threshold to discard excess traffic.
• E.Enable packet remarking for priority traffic.

Comment: *

Name: *

Email: *

Verification: *

What are two features of stateful NAT64? (Choose two.)

• A.It uses address overloading.
• B.It provides 1:N translations, so it supports an unlimited number of endpoints.
• C.It requires IPv4-translatable IPv6 address assignments.
• D.It requires the IPv6 hosts to use either DHCPv6-based address assignments or manual address assignments.
• E.It provides 1:1 translation, so it supports a limited number of endpoints.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which purpose of implementing NSF with this configuration is true?

• A.The router uses NSF to load balance traffic between two links, with the primary link alternating every 90 seconds
• B.The router uses NSF to handle RP switchover while allowing neighbor relationships to remain up
• C.The router uses NSF to load balance traffic on a routed EtherChannel
• D.The router uses NSF to reduce neighbor-relationship downtime during RP switchover

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the LDP features from the left onto the correct usages on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer is configuring a new router for iBGP to improve the capacity of a growing network. The router must establish an iBGP peer relationship with its neighbor. The underlay network is already configured with the correct IP addresses. Which step should the engineer apply to complete this task?

• A.Activate the BGP peers under the correct address family on the router.
• B.Configure the new router as an iBGP route reflector to support multiple iBGP peers.
• C.Configure the AS number for the router to share with its iBGP peers.
• D.Implement multicast routing on the router to support BGP hellos.

Comment: *

Name: *

Email: *

Verification: *