An engineer implements SPAN configuration on an Nexus 5000 series switch. Which two commands are necessary to complete the SPAN session configuration? (Choose two)

• A.Configure switchport speed 4000 under interface fc2/2.
• B.Configure the switchport mode SD under interface fc2/2.
• C.Configure the switchport monitor under interface fc2/2
• D.Configure the switchport mode SD under interface tc2/1.
• E.Configure session type fc under monitor session 1.

Comment: *

Name: *

Email: *

Verification: *

A company is running a pair of cisco Nexus 7706 series switches as part of a data center segment. All network engineers have restricted read-Write access to the core switches. A network engineer must a new FCoE VLAN to allow traffic from services toward FCoE storage. Which set of actions must be taken to meet these requirements?

• A.Commit the changes to the active user database.
• B.1. Modify a network-operator role and add the required privileges.
  2. Assign a VDC-operator role to a user.
• C.1. Create a user defined role and add the required privileges.
  2. Assign a role to a user.
• D.1. Assign the network-admin role to a user.
  2. Commit the role to the switch to the active user database
• E.1. Add the required privilege to the VDC-admin role.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

In a bidirectional PIM network using Phantom RP as an RP redundancy mechanism, two Cisco NX-OS routers have these requirements:
* R1 must be the active RP.
* R2 must be the backup RP that is used only if R1 is not reachable
Drag and drop the configuration steps to complete the configuration for Router 2. Not all configuration steps are used.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is implementing zoning on two Cisco MDS switches. After the implementation is finished, E Ports that connect the two Cisco MDS switches becomes isolated. What is wrong with the implementation?

• A.E Ports on both MDS switches must be configured as F ports for the zoning to function.
• B.Zones must have the same name on both MDS switches for the E ports to function.
• C.Different zone set names must be configured on both MDS switches.
• D.Zones are local to the MDS switch and name service must be used to activate the connection between E ports.

Comment: *

Name: *

Email: *

Verification: *

Which event is expected during direct upgrade of Cisco UCS Manager firmware?

• A.IPMI polling is interrupted.
• B.All users logged in to the UCSM are logged out, and their sessions end.
• C.Data traffic is disrupted for a single fabric interconnect setup.
• D.The I/O Module reboots immediately after the firmware is activated.

Comment: *

Name: *

Email: *

Verification: *