A network engineer must implement RBAC on Cisco MDS 9000 Series Multilayer Switches.
Drag and drop the Cisco MDS 9000 Series roles from the left onto the correct categories on the right.

Correct Answer:

Explanation:
Graphical user interface Description automatically generated with low confidence

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Admin- Management/3-1/ b_Cisco_UCS_Admin_Mgmt_Guide_3_1/b_UCSM_Admin_Mgmt_Guide_chapter_01.html
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/8_x/config/security/ cisco_mds9000_security_config_guide_8x/configuring_users_and_common_roles.html#con_1422305

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A source is sending a multicast traffic stream to the receiver. How is the multicast traffic expected to flow through the network when it reaches a vPC peer?

• A.* The multicast traffic is replicated to the ports that joined a given multicast group and the peer link.
  * The multicast traffic stream flows over the peer link to ensure that orphan ports receive the multicast stream in failure scenarios.
• B.* The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link.
  * The multicast traffic stream flows over the vPC link to ensure that orphan ports get the multicast stream in failure scenarios.
• C.* The multicast traffic is replicated to the ports that joined a given multicast group and the peer link.
  * The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.
• D.* The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link.
  * The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.

Comment: *

Name: *

Email: *

Verification: *

An engineer must configure a Nexus 7000 series switch for HSRP on VLAN 100. When fully functional, the router must be the active master. Which set of commands must be used to implement the scenario?

• A.Option D
• B.Option C
• C.Option A
• D.Option B

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer needs to implement streaming telemetry on a cisco MDS 9000 series switch.
The requirement is for the show command data to be collected every 30 seconds and sent to receivers. Which command must be added to the configuration meet this requirement?

• A.Sensor-grp 200 sample-period 30000
• B.Snsr-grp 200 sample-interval 30
• C.Sensor-grp 200 sample-period 30
• D.Snsr-grp 200 sample-interval 30000

Comment: *

Name: *

Email: *

Verification: *

What is an advantage of NFSv4 over Fibre Channel protocol?

• A.Improved security
• B.Lossless throughout
• C.Congestion management
• D.Uses IP transport

Comment: *

Name: *

Email: *

Verification: *