An engineer must configure a named VSAN when the fabric interconnect is in Fibre Channel switch mode The VSAN must meet these requirements:
* Named VSAN must be called " VSAN 10 " .
* VSAN ID must be 10.
* FCoE ID must be 20.
* VSAN 10 must be attached to port 2 in slot 1.
Which command set configures a VSAN when the fabric interconnect is in Fibre Channel switch mode?

• A.Option D
• B.Option B
• C.Option A
• D.Option C

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer configures FCoE in a newly installed data center Which configuration must be applied to activate VSAN 100 on VFC 100?

• A.Allow VSAN 100 on interface eth1/12.
• B.Map an FCoE VLAN to VSAN 100.
• C.Issue the shutdown lan command on VFC 100
• D.Configure a VLAN on VFC 100.

Comment: *

Name: *

Email: *

Verification: *

An engineer must configure a named VSAN when the fabric interconnect is in Fibre Channel switch mode The VSAN must meet these requirements:
* Named VSAN must be called "VSAN 10".
* VSAN ID must be 10.
* FCoE ID must be 20.
* VSAN 10 must be attached to port 2 in slot 1.
Which command set configures a VSAN when the fabric interconnect is in Fibre Channel switch mode?

• A.Option C
• B.Option D
• C.Option A
• D.Option B

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer configures a new application profile using REST API and receives this error massage. Which method can be used before application profile can be configured?

• A.POST to aaaLogin
• B.POST to aaaRefresh
• C.POST to aaaLogout
• D.GET to aaaListDomains

Comment: *

Name: *

Email: *

Verification: *

An engineer must migrate a Cisco UCS C-Series server from Cisco SingleConnect to direct integration mode.
The Cisco UCS Manager Rack Server Discovery Policy and Rack Management Connection Policy are set to immediate and Auto-Acknowledge. Which set of steps accomplishes this task?

• A.Disconnect the cables from the FEX.Connect the cables to server ports on the fabric interconnect.Reacknowledge the server.
• B.Disconnect the cables from the FEX.Connect the cables to server ports on the fabric interconnect.Reset the Cisco IMC of the server.
• C.Disconnect the cables from the FEX.Connect the cables to appliance ports on the fabric interconnect.Reacknowledge the server
• D.Disconnect the cables from the FEX.Connect the cables to appliance ports on the fabric interconnectReset the Cisco IMC of the server.

Comment: *

Name: *

Email: *

Verification: *