Regarding SIP integrations with Cisco Unified Communications Manager, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how should the addressing mode be set up in the Cisco Unity Connection?

• A.Set up is not required.
• B.Set up for each group to use IPv4 and IPv6.
• C.Set up media ports for each port group to use IPv4.
• D.Set up IPv4 and IPv6 in Cisco Unified CM.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An administrator accesses the terminal of a Cisco UCM and starts a packet capture. Which two commands must the administrator use on Cisco UCM to generate DNS traffic? (Choose two.)

• A.show version active
• B.utils diagnose lest
• C.utils diagnose module validate_network
• D.utils ntp status
• E.show cdp neighbor

Comment: *

Name: *

Email: *

Verification: *

Regarding SIP integrations with Cisco Unified Communications Manager, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how should the addressing mode be set up in the Cisco Unity Connection?

• A.Set up media ports for each port group to use IPv4.
• B.Set up is not required.
• C.Set up for each group to use IPv4 and IPv6.
• D.Set up IPv4 and IPv6 in Cisco Unified CM.

Comment: *

Name: *

Email: *

Verification: *

Which version is used to provide encryption for SNMP management traffic in collaboration deployments?

• A.SNMPv3
• B.SNMPv2
• C.SNMPv1
• D.SNMPv2c

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The SDP offer/answer has been completed successfully but there is no DTMF when users press keys. What is the cause of the issue?

• A.G.729 rather than G.711ulaw was negotiated.
• B.DTMF was negotiated properly in these messages.
• C.Payload type 110 was negotiated rather than type 101.
• D.DTMF was not negotiated on the call.

Comment: *

Name: *

Email: *

Verification: *