A Cisco Telepresence SX80 suddenly has issues displaying main video to a display over HDMI.
Which command can you use from the SX80 admin CLI to check the video output status to the monitor?

• A.xStatus HDMI Output
• B.xStatus video Output
• C.xconfiguration video Output
• D.xcommand video status

Comment: *

Name: *

Email: *

Verification: *

What is a function of a call handler in Cisco Unity Connection?

• A.It answers calls, take messages, and provide menus of options.
• B.It controls outgoing calls by allowing an administrator to specify the numbers that Cisco Unity Connection dials to transfer calls, notify users of messages, and deliver faxes
• C.It provides access to a corporate directory by playing an audio list that users and outside callers use to reach users and leave messages.
• D.It collects information from callers by playing a series of questions and recording the answers.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An administrator is attempting to register a SIP phone to a Cisco UCM but the registration is failing. The IP address of the SIP Phone is 10.117.34.222 and the IP address of the Cisco UCM is 10.0.101.10. Pings from the SIP phone to the Cisco UCM are successful. What is the cause of this issue and how should it be resolved?

• A.An NTP mismatch is preventing the connection of the TCP session between the SIP phone and the Cisco UCM. The SIP phone and Cisco UCM must be set with identical NTP sources.
• B.DNS lookup for the Cisco UCM FQDN is failing. The SIP phone must be reconfigured with the proper DNS server.
• C.The certificates on the SIP phone are not trusted by the Cisco UCM. The SIP phone must generate new certificates.
• D.An network device is blocking TCP port 5060 from the SIP phone to the Cisco UCM. This device must be reconfigured to allow traffic from the IP phone.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An administrator must replace the T1 card with an E1 card.
What is the correct configuration if the administrator was asked to configure 12 time slots?

• A.
• B.
• C.
• D.

Comment: *

Name: *

Email: *

Verification: *

Which configuration on Cisco Unified Communication Manager is required for SIP MWI to work?

• A.The line partition must be inside the rerouting CSS assigned to the Cisco assigned to the Cisco unity connection SIP trunk.
• B.Set the "Enable message waiting indicator" on the port group.
• C.Assign a MWI extension on the mailbox.
• D.The line partition must be inside the inbound CSS assigned to the CUC SIP trunk.

Comment: *

Name: *

Email: *

Verification: *