How must the queue sizes be designed to ensure that an application functions correctly?

• A.Each individual device queuing delay in the chain must be less than or equal to the application required delay.
• B.The queuing delay on every device in the chain must be exactly the same to the application required delay.
• C.The sum of the queuing delay of all devices plus serialization delay in the chain must be less than or equal to the application required delay.
• D.The default queue sizes are good for any deployment as it compensates the serialization delay.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit A service provider has a requirement to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP- SW2 Which two ways to design this solution are true?
(Choose two)

• A.Use upward maintenance endpoints on the SP switches
• B.Enable unicast heartbeat messages to be periodically exchanged between MEPs
• C.Forward E-LMI PDUs over VPLS
• D.Enable Connectivity Fault Management on the SP switches
• E.Forward LLD PDUs over the VPLS

Comment: *

Name: *

Email: *

Verification: *

Which two actions must merchants do to be compliant with the Payment Card Industry Data Security Standard? (Choose two.)

• A.establish risk management policies
• B.conduct risk analyses
• C.establish monitoring policies
• D.install firewalls
• E.use antivirus software

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the optical technology design characteristics on the left to the correct optical technologies on the right. Not all options are used

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit Company XYZ is a large enterprise network where the WAN traffic utilizes most of the link. The IT team in the company often reports Stuck-In-Active problems The company is set to acquire another company that will also be running EIGRP and which will connect to the Company XYZ R3 and R4 routers This acquisition could make the issue worse Which design solution solves this problem?

• A.Advertise only the default route to R5 and R6. filtering all other routes.
• B.Deploy the EIGRP stub capability on R5 and R6 with the connected and summary options enabled.
• C.Utilize the EIGRP unequal cost load-balancing feature on R5 and R6 to provide an intenm solution
• D.Implement EIGRP Route Flap Dampening

Comment: *

Name: *

Email: *

Verification: *