Free Cisco 500-601 Exam Dumps Questions & Answers

Which option describes the correct sequence to discover an ESX server in the fabric without a blade switch or multiple Layer 2 hops?

• A.  The ARC receives LLDP/CDP information from the vCenter, the APIC downloads policy for VMs behind ESX to the leaf node, the leaf sends LLDP/CCP to the ESX, and the ESX sends parsed LLDP/CDP information to the vCenter.
• B.  The ESX sends parsed LLDP/CDP information to the vCenter, the leaf sends LLDP/CCP to the ESX, the APIC downloads the policy for VMs behind the ESX to the leaf node, and the APIC receives LLDP/CDP information from the vCenter.
• C.  The leaf sends LLDP/CDP to the ESX, the ESX sends parsed UDP/CDP information to the vCenter, the AP1C receives LLDP/CDP information from the vCenter, and the APIC downloads the policy for VMs behind the ESX to the leaf node.
• D.  The APIC downloads the policy for VMs behind ESX to the leaf node, the leaf sends LLDP/CCP to the ESX, the ESX sends parsed LLDP/CDP information to the vCenter, and the APIC receives LLDP/CDP information from the vCenter.

Which Cisco UCS policy is required for VM endpoints to be discovered by the Cisco ACI fabric?

• A.  LACP policy
• B.  dynamic vNIC connection policy
• C.  network control policy
• D.  LAN connectivity policy

Refer to the exhibit

Which option is a potential reason why you would see this output while provisioning a DVS?

• A.  The Service Content process has crashed.
• B.  Cisco Discovery Protocol is disabled on the vswitch policy tied to the corresponding AAEP.
• C.  The specified data center does not exist on the vCenter m question.
• D.  The Cisco APIC(s) cannot reach the vCenter host/vm.

Which command is used to successfully SSH into a Cisco ARC or switch CLI using a remote authentication server?

• A.  apic#rad_check//[email protected]
• B.  ssh apic@rad_check\\[email protected]
• C.  ssh apic#rad_check\\[email protected]
• D.  ssh apic#ad_check//[email protected]

Where does the subnet address of the distributed gateway need to be configured when route leaking is required?

• A.  in the endpoint bridge domain
• B.  in a shared bridge domain in the tenant common
• C.  under the contract provider EPG
• D.  under the contract consumer EPG