What is the result of enabling the Core File Exporter in UCS Manager?

• A.If a subsequent triggering event occurs, a core dump will be generated and sent by TFTP
• B.A core dump must be remotely activated by Cisco TAC.
• C.A core dump file will be immediately created and transmitted using HTTP protocol
• D.A core dump will immediately be generated and will be exported

Comment: *

Name: *

Email: *

Verification: *

Which statement regarding the UCS C-senes connectivity modes best describes connectivity options in a UCS Manager integrated environment?

• A.UCS C-series servers must be connected to Fabric Interconnects using Fabric Extenders (FEX)
• B.All UCS C-series servers in a single UCS Manager domain must share the same connectivity model
• C.UCS C-series servers may be connected to multiple UCS Manager domains at the same time
• D.UCS C-series servers may be connected with or without the use of Fabric Extenders (FEX) in environments running UCS Manager Software Release 2 2 or later

Comment: *

Name: *

Email: *

Verification: *

When server is booting from SAN, which command verifies the PLOGI sessions with the target?

• A.Lunmap
• B.FCMap
• C.Lunlist
• D.FCIist

Comment: *

Name: *

Email: *

Verification: *

The UCS Chassis Discovery Policy has been set to four and a new chassis is connected with two links What is the resulting chassis recognition action?

• A.The Chassis Discovery Policy will automatically reset to two links, since it always tracks the physical connections
• B.The chassis will be recognized but only one of the links will be active.
• C.The chassis will not be recognized
• D.The chassis will be recognized and both links will be active

Comment: *

Name: *

Email: *

Verification: *

When configuring UCS SAN Connectivity to a 3rd Party FibreChannel Storage Array that is connecting directly to the UCS Fabric Interconnects, which option is Cisco recommended'?

• A.Direct connectivity between UCS Fabric Interconnects and FibreChannel Storage Arrays is not supported
• B.Connect the Storage Array to an Appliance Port and Enable NPV Mode on the UCS Fabric Interconnects
• C.Connect the Storage Array to an Appliance Port and Enable Switching Mode on the UCS Fabric Interconnects
• D.Connect the Storage Array to a FC Storage Port and Enable Switching Mode on the UCS Fabric Interconnects
• E.Connect the Storage Array to a RC Storage Port and Enable NPV Mode on the UCS Fabric Interconnects

Comment: *

Name: *

Email: *

Verification: *