A second router was installed on a network to be used as a backup for the primary router that works as a
gateway. The infrastructure team does not want to change the IP address of the gateway on the devices.
Which of the following network components should be used in this scenario?
A network administrator is creating a new WLAN that should only be used by legacy devices that do not support a secure method c following should be configured to provide connectivity and minimal security to the new network? (Select TWO).
Multiple users are reporting that they are unable to access the network. The ENTIRE network is shown in the diagram. PCs are not statically assigned IP addresses. The following devices will display settings:
* WorkstationA
* WorkstationB
* WorkstationC
* WorkstationD
* WorkstationE
* WorkstationF
* WorkstationG
* Laptop1
* Laptop2
* DHCP server1
* DHCP server2
Review the settings and select the box in the diagram that identifies the device causing the issue.
Only one device can be selected at a time.
After checking the device that is causing the issue, select the second tab in the lower left hand corner. Identify the reason as to why some users are unable to access the network.
Instructions:
When the simulation is complete, select the Done button to submit.
After checking the device that is causing the issue, select the second tab in the lower left hand corner. Identify the reason as to why some users are unable to access the network. When the simulation is complete, select the Done button to submit.
Part 2 - Identify the reason as to why some users are unable to access the network.
* Workstation(s) are plugged into switch ports configured with half duplex.
* The site-to-site router was configured with the incorrect ACL.
* DHCP server scope is full and is not providing IP addresses.
* WAN and LAN ports are reversed on the router.
* STP had disabled some of the ports on the switch.
* The NIC driver is not installed.
* A wireless client is unable to associate to the AP.
SIMULATION
Your company recently purchased a new building down the street from the existing office. For each of the tasks below, select the appropriate antenna type and encryption object for all wireless access point (AP).
1. Create an encrypted wireless connection between the two buildings that BEST controls signal propagation, while maximizing security.
2. Restrict the wireless signal generated by the access points (APs) inside Building 1, so that it minimizes broadcast beyond the building.
3. Maximize wireless coverage inside Building 1.
4. Building 1's internal wireless network is for visitors only and must not require any special configuration on the visitor's device to connect.
Instructions: When you have completed the simulation, select the Done button to submit.
A firewall technician has received calls stating the network is running slowly. The technician has found the firewall is functioning properly. Which of the following should the technician review to determine the cause of the slow performance?
