Multiple users are reporting that they are unable to access the network. The ENTIRE network is shown in the diagram. PCs are not statically assigned IP addresses. The following devices will display settings:
WorkstationA
WorkstationB
WorkstationC
WorkstationD
WorkstationE
WorkstationF
WorkstationG
Laptop1
Laptop2
DHCP server1
DHCP server2
Review the settings and select the box in the diagram that identifies the device causing the issue.
Only one device can be selected at a time.
After checking the device that is causing the issue, select the second tab in the lower left hand corner. Identify the reason as to why some users are unable to access the network.
Instructions:
When the simulation is complete, select the Done button to submit.
After checking the device that is causing the issue, select the second tab in the lower left hand corner. Identify the reason as to why some users are unable to access the network. When the simulation is complete, select the Done button to submit.
Part 2 - Identify the reason as to why some users are unable to access the network.
Workstation(s) are plugged into switch ports configured with half duplex.
The site-to-site router was configured with the incorrect ACL.
DHCP server scope is full and is not providing IP addresses.
WAN and LAN ports are reversed on the router.
STP had disabled some of the ports on the switch.
The NIC driver is not installed.
A wireless client is unable to associate to the AP.
Lab Simulation
You have been tasked with setting up a wireless network in an office. The network will consist of
3 access points and a single switch. The network must meet the following parameters.
- The SSIDs need to be configured as corpnet with a key of S3cr3t!
- The wireless signals should not interfere with each other
- The subnet the Access points and Switch are on should only support 30 devices maximum
- The access Points should be configured to only support TKIP clients at a maximum speed
Instructions: Click on the devices to review their information and adjust the setting of the APs to meet the given requirements.
A network technician wants to remotely and securely access the desktop of a Linux workstation.
The desktop is running remote control software without encryption. Which of the following should the technician use to secure the connection?
A firewall that operates at Layer 7 of the OSI model is known as a(n):
A network administrator is configuring a link-state routing protocol for traffic. Which of the following routing protocols should be implemented?
