Free Access to CompTIA.N10-008.v2025-06-03.q684 with Valid Practice Test (Page 4)

Request Exam Contact

Home
View All Exams
New QA's
Upload

PRACTICE EXAMS:

Oracle
Fortinet
Juniper
Microsoft
Cisco
Citrix
CompTIA
VMware
ISC
SAP
EMC
PMI
HP
Salesforce
Other

Oracle
Fortinet
Juniper
Microsoft
Cisco
Citrix
CompTIA
VMware
ISC
SAP
EMC
PMI
HP
Salesforce

Home
CompTIA Certification
N10-008 Exam
CompTIA.N10-008.v2025-06-03.q684 Dumps

«
1
2
3
4
5
6
7
8
9
10
…
»
»»

Question 11

At which of the following OSI model layers does an IMAP client run?

A.Layer 7
B.Layer 2
C.Layer 4
D.Layer 6

Correct Answer: A

Comment: *

Name: *

Email: *

Verification: *

insert code

Question 12

A corporation has a critical system that would cause unrecoverable damage to the brand if it was taken offline. Which of the following disaster recovery solutions should the corporation implement?

A.Full backups
B.Load balancing
C.Hot site
D.Snapshots

Correct Answer: C

A hot site is the disaster recovery solution that the corporation should implement for its critical system that would cause unrecoverable damage to the brand if it was taken offline. A hot site is a fully operational backup site that can take over the primary site's functions in case of a disaster or disruption. A hot site has all the necessary hardware, software, data, network connections, and personnel to resume normal operations with minimal downtime. A hot site is suitable for systems that require high availability and cannot afford any data loss or interruption. Reference: https://www.enterprisestorageforum.com/management/disaster-recovery-site/ 1

Comment: *

Name: *

Email: *

Verification: *

insert code

Question 13

A company's web server is hosted at a local ISP. This is an example of:

A.colocation.
B.an on-premises data center.
C.a branch office.
D.a cloud provider.

Correct Answer: A

Co-location refers to the way IT equipment and resources are located or installed. This usually refers to the networking hardware resources owned by an organization, such as Web or database servers, which are located outside the vicinity of the organization's premises and "co-located" with another organization's hardware, usually an ISP or a service provider. This is usually done because the ISP might be the best candidate for maintaining the Web server hardware for the organization and it would be better to keep the hardware in a more suitable place since ISPs have specially built places for networking hardware.

Comment: *

Name: *

Email: *

Verification: *

insert code

Question 14

The following instructions were published about the proper network configuration for a videoconferencing device:
"Configure a valid static RFC1918 address for your network. Check the option to use a connection over NAT." Which of the following is a valid IP address configuration for the device?

A.FE80::1
B.100.64.0.1
C.169.254.1.2
D.172.19.0.2
E.224.0.0.12

Correct Answer: D

172.19.0.2 is a valid IP address configuration for the device that uses a static RFC1918 address for the network and allows for a connection over NAT (Network Address Translation). RFC1918 addresses are private IP addresses that are not routable on the public Internet and are used for internal networks. The RFC1918 address ranges are 10.0.0.0/8, 172.16.0.0/12, and 192.168.0.0/16. NAT is a technique that translates private IP addresses to public IP addresses when communicating with external networks, such as the Internet. FE80::1 is an IPv6 link-local address that is not a static RFC1918 address and does not allow for a connection over NAT. 100.64.0.1 is an IPv4 address that belongs to the shared address space range (100.64.0.0/10) that is used for carrier-grade NAT (CGN) between service providers and subscribers, which is not a static RFC1918 address and does not allow for a connection over NAT. 169.254.1.2 is an IPv4 link-local address that is automatically assigned by a device when it cannot obtain an IP address from a DHCP server or manual configuration, which is not a static RFC1918 address and does not allow for a connection over NAT. 224.0.0.12 is an IPv4 multicast address that is used for VRRP (Virtual Router Redundancy Protocol), which is not a static RFC1918 address and does not allow for a connection over NAT.

Comment: *

Name: *

Email: *

Verification: *

insert code

Question 15

Which of the following demarcation connections would be MOST appropriate to use with a cable modem being installed in a SOHO situation?

A.RG6
B.Cat 6
C.RJ11
D.Multimode fiber

Correct Answer: A

RG6 is a type of coaxial cable that is commonly used for cable TV and internet services. A cable modem is a device that modulates and demodulates signals over a coaxial cable network to provide broadband internet access. A SOHO situation refers to a small office/home office environment that typically has a single cable modem connected to a single coaxial cable outlet. Therefore, RG6 is the most appropriate demarcation connection for a cable modem in a SOHO situation. References: [CompTIA Network+ Certification Exam Objectives], What Is RG6 Cable? | Techwalla

Comment: *

Name: *

Email: *

Verification: *

insert code

«
1
2
3
4
5
6
7
8
9
10
…
»
»»

[×]

Download PDF File

Enter your email address to download CompTIA.N10-008.v2025-06-03.q684 Dumps

Email:

Our website provides the Largest and the most Latest vendors Certification Exam materials around the world.

Using dumps we provide to Pass the Exam, we has the Valid Dumps with passing guranteed just which you need.

DMCA
About
Contact Us
Privacy Policy
Terms & Conditions

©2026 FreeQAs

www.freeqas.com materials do not contain actual questions and answers from Cisco's certification exams.

Web Analytics Made Easy - Statcounter