FreeQAs
 Request Exam  Contact
  • Home
  • View All Exams
  • New QA's
  • Upload
PRACTICE EXAMS:
  • Oracle
  • Fortinet
  • Juniper
  • Microsoft
  • Cisco
  • Citrix
  • CompTIA
  • VMware
  • ISC
  • SAP
  • EMC
  • PMI
  • HP
  • Salesforce
  • Other
  • Oracle
    Oracle
  • Fortinet
    Fortinet
  • Juniper
    Juniper
  • Microsoft
    Microsoft
  • Cisco
    Cisco
  • Citrix
    Citrix
  • CompTIA
    CompTIA
  • VMware
    VMware
  • ISC
    ISC
  • SAP
    SAP
  • EMC
    EMC
  • PMI
    PMI
  • HP
    HP
  • Salesforce
    Salesforce
  1. Home
  2. CompTIA Certification
  3. SK0-005 Exam
  4. CompTIA.SK0-005.v2024-04-11.q408 Dumps
  • ««
  • «
  • …
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • …
  • »
  • »»
Download Now

Question 136

After configuring IP networking on a newly commissioned server, a server administrator installs a straight- through network cable from the patch panel to the switch. The administrator then returns to the server to test network connectivity using the ping command. The partial output of the ping and ipconfig commands are displayed below:

The administrator returns to the switch and notices an amber link light on the port where the server is connected. Which of the following is the MOST likely reason for the lack of network connectivity?

Correct Answer: D
Explanation
A misconfigured NIC on the server is the most likely reason for the lack of network connectivity. The output of the ping command shows that the server is unable to reach its default gateway (10.0.0.1) or any other IP address on the network. The output of the ipconfig command shows that the server has a valid IP address (10.0.0.10) and subnet mask (255.255.255.0) but no default gateway configured. This indicates that there is a problem with the NIC settings on the server, such as an incorrect IP address, subnet mask, default gateway, DNS server, etc. A misconfigured NIC can also cause an amber link light on the switch port, which indicates a speed or duplex mismatch between the NIC and the switch.
insert code

Question 137

A storage administrator needs to implement SAN-based shared storage that can transmit at 16Gb over an optical connection. Which of the following connectivity options would BEST meet this requirement?

Correct Answer: A
Fibre Channel is a connectivity option that can transmit at 16Gb over an optical connection for SAN-based shared storage. Fibre Channel is a high-speed network technology that provides reliable and secure data transfer between servers and storage devices. Fibre Channel uses optical fiber cables to connect devices and supports various topologies and protocols. FCoE is another connectivity option that uses Fibre Channel over Ethernet, which encapsulates Fibre Channel frames into Ethernet packets. FCoE can also transmit at 16Gb over an optical connection, but it requires a converged network adapter (CNA) and a lossless Ethernet network. iSCSI is another connectivity option that uses SCSI commands over IP networks, which can use either copper or optical cables. iSCSI can transmit at 10Gb or 40Gb over an optical connection, but it has higher latency and lower performance than Fibre Channel. eSATA is another connectivity option that uses SATA commands over external cables, which are usually copper. eSATA can transmit at 6Gb over a copper connection, but it has limited cable length and device support compared to Fibre Channel. Reference:
https://www.ibm.com/topics/storage-area-network
https://www.techopedia.com/definition/1369/fibre-channel-fc
https://www.techopedia.com/definition/1368/fibre-channel-over-ethernet-fcoe
https://www.techopedia.com/definition/1367/internet-small-computer-system-interface-iscsi
https://www.techopedia.com/definition/1366/external-serial-advanced-technology-attachment-esata
insert code

Question 138

A company has a data center that is located at its headquarters, and it has a warm site that is located 20mi (32km) away, which serves as a DR location. Which of the following should the company design and implement to ensure its DR site is adequate?

Correct Answer: D
Explanation
A DR site is a backup site that can be used to restore business operations in case of a disaster that affects the primary site. A warm site is a DR site that has some equipment and data ready to be activated quickly, but not as fast as a hot site that has fully operational systems and data. A cold site is a DR site that has only basic infrastructure and no equipment or data. The location of a DR site is an important factor to consider when designing and implementing a DR plan. A DR site that is too close to the primary site may be affected by the same disaster, such as a power outage, a flood, or an earthquake. A DR site that is too far away from the primary site may incur higher costs and latency issues. Therefore, a good practice is to set up a DR site that is geographically located in another region that has different risk factors and environmental conditions than the primary site. This can help ensure that the DR site is available and accessible when needed. References:
https://www.comptia.org/training/resources/exam-objectives/comptia-server-sk0-005-exam-objectives (Objective 3.3)
insert code

Question 139

Which of the following relates to how much data loss a company agrees to tolerate in the event of a disaster?

Correct Answer: C
Below are some of the factors that can affect RPOs:
Maximum tolerable data loss for the specific organization.
Industry-specific factors - businesses dealing with sensitive information such as financial transactions or health records must update more often.
Data storage options, such as physical files versus cloud storage, can affect the speed of recovery.
The cost of data loss and lost operations.
Compliance schemes include provisions for disaster recovery, data loss, and data availability that may affect businesses.
The cost of implementing disaster recovery solutions.
insert code

Question 140

Users at a company work with highly sensitive dat
a. The security department implemented an administrative and technical control to enforce least-privilege access assigned to files. However, the security department has discovered unauthorized data exfiltration. Which of the following is the BEST way to protect the data from leaking?

Correct Answer: C
Components of a Data Loss Solution
insert code
  • ««
  • «
  • …
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • …
  • »
  • »»
[×]

Download PDF File

Enter your email address to download CompTIA.SK0-005.v2024-04-11.q408 Dumps

Email:

FreeQAs

Our website provides the Largest and the most Latest vendors Certification Exam materials around the world.

Using dumps we provide to Pass the Exam, we has the Valid Dumps with passing guranteed just which you need.

  • DMCA
  • About
  • Contact Us
  • Privacy Policy
  • Terms & Conditions
©2026 FreeQAs

www.freeqas.com materials do not contain actual questions and answers from Cisco's certification exams.