Which component must be installed before the first CPM installation?

• A.PTA
• B.EPM
• C.PSM
• D.PVWA

Comment: *

Name: *

Email: *

Verification: *

To enable LDAP over SSL for a Vault when DNS lookups are blocked, which step must be completed?

• A.Add the FQDN & IP details for each LDAP host into the local hosts file of the Vault server. Most Voted
• B.Configure an AllowNonStandardFWAddresses rule in DBParm.ini on the Vault to allow outbound TCP
  53 to the organization's DNS servers.
• C.Set the ReferralsDNSLookup parameter value to "No" in the directory configuration.
• D.Ensure LDAP hosts added to the directory mapping configuration are defined using only IP addresses.

Comment: *

Name: *

Email: *

Verification: *

What would be a good use case for the Disaster Recovery module?

• A.Off site replication is required.
• B.Integration with an Enterprise Backup Solution is required.
• C.Recovery Time Objectives or Recovery Point Objectives are at or near zero.
• D.PSM is used.

Comment: *

Name: *

Email: *

Verification: *

You are installing a CPM.
In addition to Add Safes, Add/Update Users, Reset Users' Passwords and Manage Server File Categories, which Vault authorization(s) does a CyberArk user need to install the CPM?

• A.Manage Directory Mapping
• B.Activate Users
• C.Audit Users, Add Network Areas
• D.Backup All Safes, Restore All Safes

Comment: *

Name: *

Email: *

Verification: *

You are setting up a Linux host to act as an HTML 5 gateway for PSM sessions.
Which servers need to be trusted by the Linux host to secure communications through the gateway?

• A.PVWA and Vault
• B.PSM and PVWA
• C.Vault and PSM
• D.PSM and CPM

Comment: *

Name: *

Email: *

Verification: *