After initiating a manual save, you receive the following error message:
- 39078
- Save
- SYSTEM error: manual saves are not enabled
What must you check to do a manual save?

• A.save syntax
• B.Run savegrp before run save
• C.EMC NetWorker Server properties
• D.Modify client access list and grant access for all clients

Comment: *

Name: *

Email: *

Verification: *

A Dell EMC NetWorker administrator wants to back up all data residing on a cluster which consists of two physical nodes with one virtual service. The cluster is in an active/passive configuration.
Where must the NetWorker client software be installed?

• A.On each physical node and the virtual service
• B.On each physical node only
• C.On only the passive node
• D.On only the active node

Comment: *

Name: *

Email: *

Verification: *

To which items do NetWorker directives apply?

• A.NAS backups, physical servers, and NetWorker module backups
• B.block-based backups, snapshots, NAS backups, and NetWorker module backups
• C.guest-level backups of virtual machines and block-based backups
• D.physical servers and guest-level backups of virtual machines

Comment: *

Name: *

Email: *

Verification: *

A Dell EMC NetWorker administrator needs to configure Data Domain with DD Boost as a backup target in a newly installed environment. The administrator is using the EMC Licensing Solution.
Which licenses, if any, must be added on the NetWorker server?

• A.Data Domain Disk Backup Option and Storage Node
• B.DD Boost and OPENSTORAGE
• C.Data Domain Storage System and Data Domain Capacity Entitlement
• D.No special licensing is required

Comment: *

Name: *

Email: *

Verification: *

Refer to the Exhibit.

What is the size of the EMC NetWorker synthetic full on Wednesday?

• A.1.1 TB
• B.1.5 TB
• C.1.85 TB
• D.0.75 TB

Comment: *

Name: *

Email: *

Verification: *