Which IPv6prefixidentiies multicast?

• A.FA00::/8
• B.FC00::/8
• C.FE00::/8
• D.FF00::/8

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

No static routing has been configured. For iBGP loopback-based peering, which statement is correct?

• A.S1 should have the Loopback network of S3 in its routing table for loopback-based peering.
• B.For iBGP peering, physical interface addresses must be used.
• C.It is not necessary for the routing table on S1 to have an entry for the loopback network of S3.
• D.A static route on S1 to 144.254.32.1/32 will eliminate the need for loopback-based peering with S3.

Comment: *

Name: *

Email: *

Verification: *

Which user role in OS10 has full access to all commands and exclusive access to commands that manipulate the file system?

• A.netoperator
• B.secadmin
• C.sysadmin
• D.netadmin

Comment: *

Name: *

Email: *

Verification: *

What OS10 command is used to remove VLAN 40 from a trunk port?

• A.no switchport mode trunk
• B.switch pert mode trunk no allow vlan 40
• C.switchport trunk delete vlan 40
• D.no switchport trunk allowed vlan 40

Comment: *

Name: *

Email: *

Verification: *

You have been asked to examine a BGP configuration for a co-worker who is having difficulty establishing BGP peering. The address shown is that of the neighbor's Lo0 interface.
Given the configuration shown, what would be your recommendation?
S3(config-router-bgp-65042)# neighbor 192.168.32.1
S3(config-router-neighbor)# remote-as 65042

• A.Add the following to the existing configuration: S3(config-router-neighbor)# update- source loopback 0 S3(config-router-neighbor)# no shutdown
• B.Modify the existing configuration to be: S3(config-router-bgp-65042)# neighbor 192.168.32.1/24 S3(config-router-neighbor)# peer-as 65042
• C.Issue the no shutdown command and verify that the BGP state is ESTABLISHED
• D.Issue the no shutdown command and verify that the BGP state is ACTIVE

Comment: *

Name: *

Email: *

Verification: *