Which BASE-T Ethernet standard specifies a CAT6 cable type?

• A.5GBASE-T
• B.10BASE-T
• C.2.5GBASE-T
• D.10GBASE-T

Comment: *

Name: *

Email: *

Verification: *

Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

• A.MXL
• B.M6220
• C.M6348
• D.M8024-K

Comment: *

Name: *

Email: *

Verification: *

A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?

• A.Change the reference speed used by OSPF in cost calculations on all switches within the path.
• B.Break the paths into multiple OSPF areas.
• C.Switch all routing protocols to RIPv2.
• D.Manually specify the OSPF Router ID on each switch within the path.

Comment: *

Name: *

Email: *

Verification: *

What is the default OSPF "hello interval"?

• A.10 seconds
• B.5 seconds
• C.15 seconds
• D.30 seconds

Comment: *

Name: *

Email: *

Verification: *

In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

• A.Listening
• B.Forwarding
• C.Blocking
• D.Learning

Comment: *

Name: *

Email: *

Verification: *