Users report that traffic is negatively affected every time a BIG-IP device fails over. The traffic becomes stabilized after a few minutes.
What should the BIG-IP Administrator do to reduce the impact of future failovers?

• A.Set up Failover Method to HA Order
• B.Configure a global SNAT Listener
• C.Enable Failover Multicast Configuration
• D.Configure MAC Masquerade

Comment: *

Name: *

Email: *

Verification: *

Which two can be a part of a virtual server's definition. (Choose two.)

• A.loadElbalancing method(s)
• B.node address(es)
• C.monitor(s)
• D.pool(s)
• E.rule(s)

Comment: *

Name: *

Email: *

Verification: *

Assume the bigd daemon fails on the active system. Which three are possible results. (Choose three.)

• A.The active system will continue in active mode but gather member and node state information from the standby system.
• B.The active system will restart the tmm daemon and continue in active mode.
• C.The active system will reboot and the standby system will go into active mode.
• D.The active system will failElover and the standby system will go into active mode.
• E.The active system will restart the bigd daemon and continue in active mode.

Comment: *

Name: *

Email: *

Verification: *

The current status of a given pool member is nknown. Which condition could explain that state. The current status of a given pool member is .nknown. Which condition could explain that state.

• A.The member has a monitor assigned to it and the most recent monitor was successful.
• B.The member has no monitor assigned to it.
• C.The member has a monitor assigned to it and the monitor did not succeed during the most recent timeout period.
• D.The member's node has a monitor assigned to it and the monitor did not succeed during the most recent timeout period.

Comment: *

Name: *

Email: *

Verification: *

When network failover is enabled, which of the following is true?

• A.The failover cable status is ignored. Failover is determined by the network status only.
• B.The presence or absence of voltage over the fail over cable takes precedence over network failover.
• C.A network failure will not cause a failover as long as there is a voltage across the failover cable.
• D.Either a network failure or loss of voltage across the failover cable will cause a failover.

Comment: *

Name: *

Email: *

Verification: *