A 8IG-IP device is replaced with an RMA device. The BIG-IP Administrator renews the license and tries to restore the configuration from a previously generated UCS archive on the RMA device. The device configuration is NOT fully loading. What is causing the configuration load to fail?

• A.The clock is NOT set correctly
• B.The Device Group is NOT configured for Full Sync.
• C.The US does NOT contain the full config
• D.The Master Key is NOT restored

Comment: *

Name: *

Email: *

Verification: *

Which parameters are set to the same value when a pair of BIGElIP devices are synchronized.

• A.system clocks
• B.profile definitions
• C.MAC masquerade addresses
• D.VLAN failElsafe settings
• E.host names

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator is creating a new Trunk on the BIG-IP device. What objects should be added to the new Trunk being created?

• A.Interfaces
• B.Network routes
• C.VLANS
• D.IP addresses

Comment: *

Name: *

Email: *

Verification: *

When using the setup utility to configure a redundant pair, you are asked to provide a "Failover Peer IP". Which address is this?

• A.an address of the other system in its management network
• B.an address on the current system used to initiate mirroring and network failover heartbeat messages
• C.an address on the current system used to listen for failover messages from the partner BIG-IP
• D.an address of the other system in a redundant pair configuration

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A pool member fails the monitor checks for about 30 minutes and then starts passing the monitor checks. New traffic is Not being sent to the pool member.
What is the likely reason for this problem?

• A.The pool member is disabled
• B.Time Until Up is zero
• C.Manual resume is enabled
• D.Monitor Type is TCP Half Open

Comment: *

Name: *

Email: *

Verification: *