-- Exhibit -

-- Exhibit --
Refer to the exhibit.
An LTM Specialist configures a virtual server to load balance to a pool of FTP servers. File transfers are failing. The virtual server is configured as follows:
ltm virtual ftp_vs {
destination 10.10.1.103:ftp
ip-protocol tcp
mask 255.255.255.255
pool ftp_pool
profiles {
tcp { }
}
vlans-disabled
}
Which change will resolve the problem?

• A.Enable loose initiation in the TCP profile.
• B.Add an FTP profile to the virtual server.
• C.Increase the TCP timeout value in the TCP profile.
• D.Add an FTP monitor to the pool.

Comment: *

Name: *

Email: *

Verification: *

An TLM Specialist has an Exchange that must use the LTM device to route traffic to the internet.
Which SNAT/NAT configure allows the Exchange server's traffic access the internet through the LTM device?

• A.NAT
• B.SNAT Automap
• C.SNAT List
• D.SNAT Pool

Comment: *

Name: *

Email: *

Verification: *

What is the recommended procedure for upgrading a major TMOS release on a BIG-IP platform?

• A.1. Renew the device license.
  2.Take a configuration backup.
  3.Upload the device code.
  4.Install device code to the non-active volume.
  5.Reboot the device to the non-active volume.
• B.1. Take a configuration backup.
  2.Reboot the device to the non-active volume.
  3.Renew the device license.
  4.Upload the device code.
  5. Install device code to the current volume.
• C.1. Take a configuration backup.
  2.Upload the device code.
  3.Install device code to the non-active volume.
  4.Reboot the device to the non-active volume.
  5.Renew the device license.
• D.1. Renew the device license.
  2.Take a configuration backup.
  3.Reboot the device to the non-active volume.
  4.Upload the device code.
  5.Install device code to the current volume.

Comment: *

Name: *

Email: *

Verification: *

An LTM Specialist has noticed in the audit log that there are numerous attempts to loginto the Admin account.
Theses attempts are sourced from a suspicious IP address range to the Configuration Utility of the LTM device.
How should the LTM Specialist block these attempts?

• A.add the suspicious source IP addresses to the httpd deny list via tmsh
• B.add the suspicious source IP addresses to the httpd deny list via Configuration Utility
• C.add the permitted source IP addresses to the allow list viaConfiguration Utility
• D.add the permitted source IP addresses to the httpd allow list viatmsh

Comment: *

Name: *

Email: *

Verification: *

Internet clients connecting to a virtual server to download a file are experiencing about 150 ms of latency and no packet loss.
Which built-in client-side TCP profile provides the highest throughput?

• A.tcp
• B.tcp-lan-optimized
• C.tcp-legacy
• D.tcp-wan-optimized

Comment: *

Name: *

Email: *

Verification: *