In FortiAnalyzer's FormView, source and destination IP addresses from FortiGate devices are not resolving to a hostname. How can you resolve the source and destination IPs, without introducing any additional performance impact to FortiAnalyzer?

• A.Configure local DNS servers on FortiAnalyzer
• B.Resolve IPs on a per-ADOM basis to reduce delay on FortiView while IPs resolve
• C.Configure # set resolve-ip enable in the system FortiView settings
• D.Resolve IPs on FortiGate

Comment: *

Name: *

Email: *

Verification: *

What does the disk status Degraded mean for RAID management?

• A.The FortiAnalyzer device is writing data to a newly added hard drive in order to restore the hard drive to an optimal state.
• B.The FortiAnalyzer device is writing to all the hard drives on the device in order to make the array fault tolerant.
• C.The hard driveiIs no longer being used by the RAID controller
• D.One or more drives are missing from the FortiAnalyzer unit. The drive is no longer available to the operating system.

Comment: *

Name: *

Email: *

Verification: *

Which clause is considered mandatory in SELECT statements used by the FortiAnalyzer to generate reports?

• A.WHERE
• B.FROM
• C.ORDER BY
• D.LIMIT

Comment: *

Name: *

Email: *

Verification: *

Which two statements regarding the log synchronization states for HA on FortiAnalyzer are true? (Choose two.)

• A.When Log Data Sync is turned on, the backup device reboots and then rebuilds the log database with the synchronized logs.
• B.Log Data Sync provides real-time log synchronization to all backup devices.
• C.By default, Log Data Sync is disabled on all backup devices.
• D.With Initial Logs Sync, when you add a unit to an HA cluster, the primary device synchronizes its logs with the backup device.

Comment: *

Name: *

Email: *

Verification: *

An administrator has configured the following settings:
config system fortiview settings
set resolve-ip enable
end
What is the significance of executing this command?

• A.It resolves the destination IP address to a hostname in FortiView on FortiAnalyzer.
• B.You must configure local DNS servers on FortiGate for this command to resolve IP addresses on Forti Analyzer.
• C.It resolves the source and destination IP addresses to a hostname in FortiView on FortiAnalyzer.
• D.Use this command only if the source IP addresses are not resolved on FortiGate.

Comment: *

Name: *

Email: *

Verification: *