What will happen if FortiAnalyzer features are enabled on FortiManager?

• A.FortiManager will enable ADOMs automatically to collect logs from non-FortiGate devices
• B.FortiManager will reboot
• C.FortiManager can be used only as a logging device.
• D.FortiManager will send the logging configuration to the managed devices so the managed devices will start sending logs to FortiManager

Comment: *

Name: *

Email: *

Verification: *

An administrator would like to create an SD-WAN using central management in the Training ADOM.
To create an SD-WAN using central management, which two steps must be completed? (Choose two.)

• A.Specify a gateway address when you create a default SD-WAN static route
• B.Enable SD-WAN central management in the Training ADOM
• C.Configure and install the SD-WAN firewall policy and SD-WAN static route before installing the SD-WAN template settings
• D.Remove all the interface references such as routes or policies that will be a part of SD-WAN member interfaces

Comment: *

Name: *

Email: *

Verification: *

View the following exhibit:

How will FortiManager try to get updates for antivirus and IPS?

• A.From the default server fdsl.fortinet.com
• B.From the configured override server list only
• C.From the list of configured override servers with ability to fall back to public FDN servers
• D.From public FDNI server with highest index number only

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibits.
Exhibit one.

Exhibit two.

An administrator created a new system template named Training with two new DNS addresses on FortiManager. During the installation preview stage, the administrator notices that many unset commands need to be pushed.
What can be the main reason for these unset commands?

• A.The ADOM is locked by another administrator
• B.The Training system template does not have assigned devices
• C.The DNS addresses in the default system settings are the same as the Training system template
• D.The Training system template has other default settings

Comment: *

Name: *

Email: *

Verification: *

An administrator would like to authorize a newly-installed AP using AP Manager. What steps does the administrator need to perform to authorize an AP?

• A.Authorize the new AP using AP Manager and install the device level settings on the managed FortiGate.
• B.Authorize the new AP using AP Manager and wait until the change is updated on the FortiAP. Changes to the AP's state do not require installation.
• C.Authorize the new AP using AP Manager and install the policy package changes on the managed FortiGate.
• D.Changes to the AP's state must be performed directly on the managed FortiGate.

Comment: *

Name: *

Email: *

Verification: *