View the following exhibit.

What is the purpose of setting ADOM Mode to Advanced?

• A.This setting allows you to assign different VDOMs from the same FortiGate to different ADOMs.
• B.The setting disables concurrent ADOM access and adds ADOM locking
• C.The setting allows automatic updates to the policy package configuration for a managed device
• D.The setting enables the ADOMs feature on FortiManager

Comment: *

Name: *

Email: *

Verification: *

An administrator would like to authorize a newly-installed AP using AP Manager. What steps does the administrator need to perform to authorize an AP?

• A.Authorize the new AP using AP Manager and install the device level settings on the managed FortiGate.
• B.Authorize the new AP using AP Manager and wait until the change is updated on the FortiAP. Changes to the AP's state do not require installation.
• C.Changes to the AP's state must be performed directly on the managed FortiGate.
• D.Authorize the new AP using AP Manager and install the policy package changes on the managed FortiGate.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibits.
Exhibit one.

Exhibit two.

An administrator created a new system template named Training with two new DNS addresses on FortiManager. During the installation preview stage, the administrator notices that many unset commands need to be pushed.
What can be the main reason for these unset commands?

• A.The Training system template has other default settings
• B.The ADOM is locked by another administrator
• C.The DNS addresses in the default system settings are the same as the Training system template
• D.The Training system template does not have assigned devices

Comment: *

Name: *

Email: *

Verification: *

What does a policy package status of Modified indicate?

• A.The policy package was never imported after a device was registered on FortiManager
• B.The Policy configuration has been changed on a managed device and changes have not yet been imported into FortiManager
• C.The Policy package configuration has been changed on FortiManager and changes have not yet been installed on the managed device.
• D.FortiManager is unable to determine the policy package status

Comment: *

Name: *

Email: *

Verification: *

An administrator wants to delete an address object that is currently referenced in a firewall policy.
What can the administrator expect to happen?

• A.FortiManager will not allow the administrator to delete a referenced address object
• B.FortiManager will replace the deleted address object with all address object in the referenced firewall policy
• C.FortiManager will replace the deleted address object with the none address object in the referenced firewall policy
• D.FortiManager will disable the status of the referenced firewall policy

Comment: *

Name: *

Email: *

Verification: *