Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

• A.Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor
• B.Areas with the signal strength weaker than -68 dB are cut out of the map
• C.Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility
• D.Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibits.
Exhibit A

Exhibit B

A wireless network has been created to support a group of users in a specific area of a building. The wireless network is configured but users are unable to connect to it. The exhibits show the relevant controller configuration for the APs and the wireless network.
Which two configuration changes will resolve the issue? (Choose two.)

• A.For both interfaces in the wtp-profile, configure set vaps to be "Authors"
• B.Disable intra-vap-privacy for the Authors vap-wireless network
• C.For both interfaces in the wtp-profile, configure vap-all to be manual
• D.Increase the transmission power of the AP radio interfaces

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

• A.Areas with the signal strength weaker than -68 dB are shown with blackbackground.
• B.Areas with the signal strength equal to -68 dB are zoomed in to providebetter visibility.
• C.Areas with the signal strength weaker than -68 dB are highlighted in orangeand red to indicate that no signal was propagated by the APS.
• D.Areas with the signal strength equal or stronger than -68 dB are highlighted in green circles.

Comment: *

Name: *

Email: *

Verification: *