Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit C

A wireless network has been installed in a small office building and is being used by a business to connect its wireless clients. The network is used for multiple purposes, including corporate access, guest access, and connecting point-of-sale and IoT devices.
Users connecting to the guest network located in the reception area are reporting slow performance. The network administrator is reviewing the information shown in the exhibits as part of the ongoing investigation of the problem. They show the profile used for the AP and the controller RF analysis output together with a screenshot of the GUI showing a summary of the AP and its neighboring APs.
To improve performance for the users connecting to the guest network in this area, which configuration change is most likely to improve performance?

• A.Increase the transmission power of the AP radios
• B.Install another AP in the reception area to improve available bandwidth
• C.Enable frequency handoff on the AP to band steer clients
• D.Reduce the number of wireless networks being broadcast by the AP

Comment: *

Name: *

Email: *

Verification: *

How are wireless clients assigned to a dynamic VLAN configured for hash mode?

• A.Using the current number of wireless clients connected to the SSID and the number of IPs available in the least busy VLAN
• B.Using the current number of wireless clients connected to the SSID and the number of clients allocated to each of the VLANs
• C.Using the current number of wireless clients connected to the SSID and the number of VLANs available in the pool
• D.Using the current number of wireless clients connected to the SSID and the group the FortiAP is a member of

Comment: *

Name: *

Email: *

Verification: *

Which of the following is a requirement to generate analytic reports using on-site FortiPresence deployment?

• A.Two wireless APs must be sending data
• B.SQL services must be running
• C.Wireless network security must be set to open
• D.DTLS encryption on wireless traffic must be turned off

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

• A.Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor
• B.Areas with the signal strength weaker than -68 dB are cut out of the map
• C.Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility
• D.Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.

Comment: *

Name: *

Email: *

Verification: *

Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)

• A.DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.
• B.DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.
• C.DARRP measurements can be scheduled to occur at specific times.
• D.DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.

Comment: *

Name: *

Email: *

Verification: *