Free Fortinet NSE6_SDW_AD-7.6 Exam Dumps Questions & Answers

What are three key routing principles of SD-WAN? (Choose three.)

• A.  Policy routes have precedence over SD-WAN rules.
• B.  SD-WAN rules are skipped if the best route to the destination is a static route
• C.  SD-WAN rules are skipped if the best route to the destination is not an SD-WAN member.
• D.  SD-WAN members are skipped if they do not have a valid route to the destination.
• E.  Directly connected routes have precedence over SD-WAN rules.

Refer to the exhibits.

The exhibits show two IPsec templates to define Branch IPsec 1 and Branch_IPsec_2. Each template defines a VPN tunnel. The error message that FortiManager displayed when the administrator tried to assign the second template to the FortiGate device is also shown.
Which statement best describes the cause of the issue?

• A.  You should review the branch1_fgt configuration for configured tunnels in the rootVDOM.
• B.  You can assign only one IPsec template to each FortiGate device.
• C.  You should use the same outgoing interface of both templates.
• D.  You can assign only one template with a tunnel type of static to each FortiGate device.

(Refer to the exhibit. The administrator configured two SD-WAN rules to load balance the traffic.

Which interfaces does FortiGate use to steer the traffic from 10.0.1.124 to 10.0.0.254 ? Choose one answer.)

• A.  port1 or port2
• B.  HUB1-VPN2 or HUB2-VPN2
• C.  HUB2-VPN2
• D.  Any interface in the HUB1 or HUB2 zones

You used the HUB IPsec_Recommended and the BRANCH IPsec_Recommended templates to define the overlay topology. Then, you used the SD-WAN template to define the SD- WAN members, rules, and performance SLAs.
You applied the changes to the devices and want to use the FortiManager monitors menu to get a graphical view that shows the status of each SD-WAN member.
Which statement best explains how to obtain this graphical view?

• A.  Use the VPN monitor map view to get a map view of the branches, hub, and tunnel status, including the SLA pass or missed status.
• B.  Use the SD-WAN monitor table view to get a donut view and a table view that shows the status of each SD-WAN member, including the SLA pass or missed status.
• C.  Use the SD-WAN monitor asset view to get a donut view and a table view that shows the status of each device and the SLA status of each SD-WAN member.
• D.  Use the SD-WAN monitor template view to get a map view of the branches, hub, and tunnel status, including the SLA pass or missed status.

Refer to the exhibits.


The administrator configured a device blueprint and CLI scripts as shown in the exhibits, to prepare for onboarding FortiGate devices in the company's stores. Later, a technician prepares a FortiGate 51G with a basic configuration and connects it to the network. The basic configuration contains the port1 configuration and the minimal configuration required to allow the device to connect to FortiManager.
After the device first connects to FortiManager, FortiManager updates the device configuration.
Based on the exhibits, which actions does FortiManager perform?

• A.  FortiManager does not update the port1 configuration because FortiManager does not change the configuration of interfaces with fgfm access.
• B.  FortiManager updates access rights only for port1. FortiManager cannot update the IP address because it was already set manually.
• C.  FortiManager updates the configuration of port1, port2, and port5. The three ports might get new IP addresses.
• D.  FortiManager updates the device configuration according to the selected templates. It applies the corp_st template first.