Refer to the exhibit, which contains a CLI script configuration on FortiManager. An administrator configured the CLI script on FortiManager, but the script failed to apply any changes to the managed device after being executed.

What are two reasons why the script did not make any changes to the managed device? (Choose two)

• A.The commands that start with the # sign did not run.
• B.Incomplete commands can cause CLI scripts to fail.
• C.Static routes can be added using only TCI scripts.
• D.CLI scripts must start with #!.

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

Refer to the exhibit which provides information on BGP neighbors
What can you conclude from this command output?

• A.The local FortiGate is having a fully established and active BGP connection with its peer
• B.The local FortiGate has initiated a TCP connection, but there is no response from its BGP peer
• C.The local FortiGate is missing the config neighbor command in its BGP configuration
• D.The local FortiGate starts sending its routing table with its iBGP peer

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit which shows two configured FortiGate devices and peering over FGSP.

The main link directly connects the two FortiGate devices and is configured using the set session- syn-dev <interface> command.
What is the primary reason to configure the main link?

• A.To have only configuration synchronization in layer 3
• B.To load balance both sessions and configuration synchronization between layer 2 and 3
• C.To have both sessions and configuration synchronization in layer 3
• D.To have both sessions and configuration synchronization in layer 2

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices.

Which two conclusions can you draw from this configuration? (Choose two)

• A.10.1.5.254 is the default gateway of the internal network
• B.On failover new primary device uses the same MAC address as the old primary
• C.The VRRP domain uses the physical MAC address of the primary FortiGate
• D.By default FortiGate B is the primary virtual router

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

Refer to the exhibit, which provides information on BGP neighbors.
Which can you conclude from this command output?

• A.The router are in the number to match the remote peer.
• B.You must change the AS number to match the remote peer.
• C.BGP is attempting to establish a TCP connection with the BGP peer.
• D.The bfd configuration to set to enable.

Comment: *

Name: *

Email: *

Verification: *