Free Fortinet NSE7_SDW-7.0 Exam Dumps Questions & Answers

Refer to the exhibit.

Based on the output, which two conclusions are true? (Choose two.)

• A.  There is more than one SD-WAN rule configured.
• B.  The all_rules rule represents the implicit SD-WAN rule.
• C.  Entry 1(id=1) is a regular policy route.
• D.  The SD-WAN rules take precedence over regular policy routes.

Refer to the exhibit.

Which statement explains the output shown in the exhibit?

• A.  FortiGate performed standard FIB routing on the session.
• B.  FortiGate must re-evaluate the session due to routing change.
• C.  FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.
• D.  FortiGate will not re-evaluate the session following a firewall policy change.

Which statement is correct about SD-WAN and ADVPN?

• A.  Routes for ADVPN shortcuts must be manually configured.
• B.  SD-WAN does not monitor the health and performance of ADVPN shortcuts.
• C.  SD-WAN can steer traffic to ADVPN shortcuts, established over IPsec overlays, configured as SD-WAN members.
• D.  You must use IKEv2 on IPsec tunnels.

Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status.
Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)

• A.  Non-TCP Facebook and YouTube traffic are not used for performance measurement.
• B.  FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.
• C.  The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.
• D.  FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.

Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

• A.  Set priority 10.
• B.  Set source 100.64.1.1.
• C.  Set load-balance-mode source-ip-ip-based.
• D.  Set cost 15.