Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

• A.Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
• B.All SD-WAN rules have the default setting enabled.
• C.Traffic does not match any of the entries in the policy route table.
• D.The sdwan_service_id flag in the session information is 0.

Comment: *

Name: *

Email: *

Verification: *

In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

• A.An absolute SD-WAN rule was defined and matched traffic.
• B.Traffic has matched none of the FortiGate policy routes.
• C.Matched traffic failed RPF and was caught by the rule.
• D.The FIB lookup resolved interface was the SD-WAN interface.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibits.

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)

• A.The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
• B.The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.
• C.The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
• D.The measured bandwidth is less than 100 KBps.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)

• A.The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
• B.T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
• C.T_INET_0_0 does not have a valid route to the destination.
• D.T_INET_1_0 has a higher member configuration priority than T_INET_0_0.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which statement explains the output shown in the exhibit?

• A.FortiGate performed standard FIB routing on the session.
• B.FortiGate must re-evaluate the session due to routing change.
• C.FortiGate will not re-evaluate the session following a firewall policy change.
• D.FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.

Comment: *

Name: *

Email: *

Verification: *