Free HP HP0-Y43 Exam Dumps Questions & Answers

View the exhibit.

A network administrator has activated connection rate filtering on an HP 8200 zl Series switch with the throttle action and medium sensitivity. However, a server connected to port A1 in VLAN 10 (IP address 10.1.10.10) needs to establish many connections with other backend servers as part of its typical behavior. The ports that this server uses are TCP 50000-50020. Based on the information provided in the exhibit, how can the network administrator ensure that this traffic is never blocked while leaving the current protections in effect?

• A.  Apply Filter2 to port A1 as a connection rate filter.
• B.  Apply Filter2 to VLAN 10 as a connection rate filter.
• C.  Apply Filter1 to port A1 as a connection rate filter.
• D.  Apply Filter1 to VLAN 10 as a connection rate filter.

A company is updating its campus LAN infrastructure, which includes a Unified Communications and Collaboration (UC&C) solution that features VoIP. What is the benefit of using HP 8206 zl core switches instead of HP 5406 zl switches?

• A.  The 8206 zl switches can provide advanced unicast and multicast routing without additional licensing.
• B.  The 8206 zl switches provide better high availability with non-stop switching and routing.
• C.  The version 2 modules on the 8206 zl switches feature up to 8 configurable hardware queues.
• D.  The 8206 zl switches support LLDP-MED and the required TLVs.

View the exhibits.
Exhibit 1
The frame has these characteristics:
> VLANID = 3
> 802.1p = 3
> DSCP=32
> Source IP address = 10.1.1.5
Click here for Exhibit 2

The frame shown in Exhibit 1 arrives on an HP 5800 switch's GigabitEthernet port 1/0/1. QoS maps are at their default settings. Based on the configuration shown in Exhibit 2, to which queue is the outbound packet assigned?

• A.  4
• B.  3
• C.  2
• D.  5

A company campus LAN requires high availability, so all edge switches have redundant links to the core. As part of the high availability design, all switches implement Multiple Spanning Tree Protocol (MSTP), and the core switches implement Virtual Router Redundancy Protocol (VRRP). Protocols are implemented to use links in the most efficient manner. What is the purpose of the link between the core switches during normal operation (when all links are up)?

• A.  The link carries VRRP messages between the VRRP Master and Backup on all VLANs.
• B.  The link does not carry any traffic but remains in forwarding state, ready to act as a backup in case another link fails.
• C.  The link acts as a backup link, blocked by MSTP in each instance but ready to transition to the forwarding state if necessary.
• D.  The link carries any traffic that arrives on the VRRP Backup to the VRRP Master.

A network includes a mix of IGMPv2 and IGMPv3 endpoints and must support the following source specific multicasting applications: -Source: 10.1.4.2 and Group: 232.0.5.5 -Source: 10.1.4.12 and Group 232.0.6.6 The network is already implementing PIM-SM and IGMPv3. In order to support these applications, the HP 10500 switches that act as routers for the endpoints in question must support another feature. Which step must the network administrator perform on each of these switches?

• A.  Enable IGMPv2 backward compatibility mode
• B.  Create an SSM policy that includes 232.0.5.5 and 232.0.6.6 within its range
• C.  Configure two SSM maps, each of which maps a source to its multicast group
• D.  Enable PIM SSM on the interfaces that connect to the endpoints