| Exam Code/Number: | HP0-Y46Join the discussion |
| Exam Name: | Implementing HP Network Technologies |
| Certification: | HP |
| Question Number: | 85 |
| Publish Date: | May 22, 2026 |
|
Rating
100%
|
|
What are factory default configuration settings of the HP MSM access points (APs)? (Select two.)
A network administrator has two distribution layer switches and four access layer switches. The network administrator is constantly resolving spanning tree problems and is looking for an alternative solution that provides redundancy and no spanning tree. Which solutions meet the network administrator's requirements? (Select two)
A network administrator receives a new HP Provision switch and notices that the software version running on the switch is older than what is currently used in the network. The network administrator copies an updated version of the operating system from the new switch's USB port to the secondary flash location. The network administrator then executes the following command:
ProVision # boot system flash secondary
The switch reboots using the new operating system. However, when the network administrator turns off the switch and turns it back on, the switch boots from the old operating system. Which solution should the network administrator use to fix the problem?
Refer to the network and ARP table exhibit.
The user on the left side of the exhibit wants to build a connection to the server on the right Assume that SwitchA and SwitchB are HP Comware switches. For which IP address does the user generate an ARP?
A network administrator executes the following command:
What is the state of the VLAN 1 interface?
