Free HP HP0-Y47 Exam Dumps Questions & Answers

HOTSPOT
Refer to the exhibit.

Exhibit 2 In exhibit 1, all infrastructure devices are implementing OSPF on the interfaces. Exhibit 1 also shows settings for OSPF areas. Exhibit 2 shows some additional OSPF settings IRF 1. The network administrator enters this command on IRF 4:

[ IRF4-ospf-1-area-0.0.0.2 ] abr-summary 10.2.0.0 16 The administrator verifies that the solution is functioning correctly. Indicate whether the link state database (LSDB) on a device should include an LSA for 10.2.0.0/16.

Correct Answer:

Refer to the exhibit. Exhibit 1

Exhibit 2

b
The HP Intelligent Resilient Framework (IRF) virtual devices shown in the Exhibit 1 support traffic for servers in VLAN 2-10. To enhance resiliency, the network administrator configures MAD on both IRF virtual switches. The administrator has established the settings shown in the exhibit 2. The configuration has an issue.
How can the administrator correct the issue?

• A.  Enable extended Link Layer Control Protocol Data Units (LACPDUs) on IRF 1 and IRF 2.
• B.  Exclude the ports in BAGG 1 from MAD on IRF 1 and IRF 2.
• C.  Activate the Bidirectional Forwarding Detection (BFD) MAD 1 on IRF 1 and IRF 2.
• D.  Change the domain ID on IRF 2 to a unique ID.

A network administrator is completing an In-Service Software Upgrade (ISSU) for an Intelligent Resilient Framework (IRF) virtual devices. The device has two members. Each member has one management module. Member1 is currently the master. The administrator has initiated a rollback time for this upgrade.
When should the administrator accept the upgrade?

• A.  After upgrading and switching over to member 2 but before upgrading member 1
• B.  After upgrading both members of the IRF virtual device
• C.  After checking the new software's ISSU compatibility but before upgrading either member
• D.  After upgrading member 1 but before switching over to and upgrading member 2

A company is implementing 802.1X authentication. These are the requirements:
- Employees who pass 802.1X authentication should be placed VLAN 3. - Guests and employees who cannot authenticate, or fail authentication, should be placed in VLAN4. - Different users might connect to port at different times, but only one device will connect to the port at the same time. - 802.1X is enabled Globally on the switch (aaa port-access authenticator)
Which settings correctly configure the HP ProVision edge ports?

• A.  Option C
• B.  Option A
• C.  Option D
• D.  Option B

For which use case is a basic or standard access control list (ACL) appropriate?

• A.  Controlling which devices can access other devices based on the MAC addresses
• B.  Controlling which devices can access other devices based on the IP addresses
• C.  Controlling which devices can access other devices based on the IP protocol number
• D.  Controlling which devices can access other devices based on the source VLAN tag