| Exam Code/Number: | HP0-Y49Join the discussion |
| Exam Name: | HP ATP FlexNetwork Solutions |
| Certification: | HP |
| Question Number: | 102 |
| Publish Date: | Oct 10, 2026 |
|
Rating
100%
|
|
What is an advantage of connecting servers directly to the HP FlexFabric?
A network administrator has just completed the initial configuration of an HP Comware switch. The network administrator saved the configuration to flash but wants to ensure that is backed up remotely to a TFTP server in case the switch fails. The TFTP server has an IP address of
10.1.100.1.
Which command must the network administrator execute to back up the current configuration of the switch?
Refer to the Exhibit.
Exhibit: HP Comware switch configuration.
[Comware] vlan 100 [Comware-vlan100] quit [Comware] vlan 200 [Comware-vlan200] quit [Comware] interface g1/0/22 [Comware-GigabitEthernet1/0/22] port link-type trunk [Comware-GigabitEthernet1/0/22] port trunk permit vlan 100 200 [Comware-GigabitEthernet1/0/22] quit
A network administrator configures the Comware switch, as shown in the exhibit. The network administrator then connects a cable from the Comware's g1/0/22 interface to port 5 on an HP ProVision switch. Which configuration will successfully establish connection for VLAN 1, 100, and 200 between the two switches?
A routing protocol has three characteristics:
-Has fast convergence with triggered, incremental updates via link state advertisements (LSAs) -Is classless protocol allowing for a hierarchical design with VLSM and route summarization -Uses an intelligent metric (cost), which is the inverse of the bandwidth of an interface
Which protocol is it?
Refer to the exhibits.
PC1 cannot reach PC2 Based on the exhibits, what could be causing this error?
