Free HP HP2-T26 Exam Dumps Questions & Answers

Which full-height device bays are in Zone 3 of a c7000 enclosure?

• A.  3 and 4
• B.  1 and 2
• C.  5 and 6
• D.  7 and 8

Using the Insight Display on a c7000 enclosure, which menu should you select to display the current condition of the enclosure?

• A.  Chat Mode
• B.  Enclosure Info
• C.  Health Summary
• D.  Enclosure Settings

A c7000 enclosure is fully populated with power supplies. Each power supply will have 2400W available if the N+1 power mode is configured. What is the total amount of available power?

• A.  7200W
• B.  14400W
• C.  16800W
• D.  12000W

Refer to the exhibit below.

A customer reports that Insight Display shows five NICs installed in a half-height server blade, but a connection to only two of them can be established. What could cause this to happen?

• A.  Some interconnect modules are powered off.
• B.  The NICs and iLO share the same interface.
• C.  The NICs are multifunction cards and also operate in iSCSI mode.
• D.  The NICs and interconnect modules are running different firmware revisions.

When installing DDR3 memory DIMMs for Gen8 servers shown, which order of slots should be followed?

• A.  slots I.J, K.L
• B.  No specific slot order is required.
• C.  slots A, B, C, D
• D.  slots A.B.L.K