Free HP HP2-Z34 Exam Dumps Questions & Answers

Why might a customer decide to use MDC instead of Multi-VPN-Instance CE (MCE)?

• A.  to provide further segmentation between tenants at the hardware or ASIC level
• B.  to manage all routing and switch functions with a single management team
• C.  to isolate tenants while maintaining the ability to leak routes in and out of a tenant instance
• D.  to integrate with Intelligent Resilient Framework (IRF)

Refer to the exhibit

An administrator is creating the EVI network shown in the exhibit Switches 1 and 2 are configured as ENDP servers. and Switch 3 is configured as an ENDP client to the ENDP servers. Which configuration is correct for the EVI tunnel interface on Switch 3?

• A.  The source IP address is the address on the connection to the service provider; the addresses for switches 1, 2, and 4 need to be set as destinations
• B.  The source IP address is the address on the connection to the service provider; no other destination IP addresses need to be set.
• C.  The source IP address is the switch router ID; no other destination IP addresses need to be set.
• D.  The source IP address is the switch router ID; the addresses for switches 1. 2. and 4 need to be set as destinations

To provide redundancy, a company has multiple data centers that use server virtualization. What is a networking requirement for this scenario?

• A.  localized storage volumes that are isolated within each data center
• B.  extension of Layer 2 connectivity across the data centers
• C.  less bandwidth at the server access layer and more bandwidth at the distribution layer than in a non-virtualized network
• D.  physical network segmentation and isolation implemented at Layers 1 through 7

What must be used when implementing the backbone multicast feature to isolate multicasts in the SPBM region?

• A.  odd-numbered VLAN IDs for B-VLANs
• B.  single l-SID for all VLANs belonging to the same customer
• C.  maximum of two Equal Cost Tree (ECT) algorithms
• D.  head-end replication for multicasts

What is the purpose of the nickname in TRILL switch settings?

• A.  Administrators can use the nicknames to identify switches in CLI output.
• B.  The nickname is the first factor for electing a root bridge
• C.  TRILL RBridges use the nicknames as source and destination addresses in TRILL headers
• D.  The nickname identifies the TRILL region and must match on every TRILL RBridge in the region.