What is a restriction of using a RoCE network?

• A.It is by default configured as an untagged network and cannot be a part of a network set.
• B.It does not support smart link and private network features.
• C.it is not supported with HPE Virtual Connect SE 40 GD F8 Module for HPE Synergy.
• D.It does not support Private VLAN and Multicast VLAN.

Comment: *

Name: *

Email: *

Verification: *

Match each HPE Synergy logical component with the definition.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

Your customer plans to deploy a VMware ESXi with HPE Synergy platform. They plan to use Distributed Switches and DRS cluster You are preparing a proposal with the following components:
- HPE Synergy frame with ten HPE Synergy 480 Gen10 Plus compute modules
- two HPE Virtual Connect SE 100Gb F32 Modules for Synergy
- an appropriate number of the vSphere Standard licenses for each compute node
- one HPE D3940 Storage Modules with 40 SSDs - all required cables and options Which statement about this proposal is true?

• A.One HPE Virtual Connect SE 100Gb F32 Module for Synergy should be replaced with 50GD/S ILM
• B.2 additional HPE Synergy 480 Gen10 Plus compute modules can be added to this setup
• C.vSphere Standard licenses should be replaced with Enterprise Pius licenses to enable requested features
• D.20 SSD drives should be removed from this setup, as D3940 supports only 20 SSD or SAS drive.

Comment: *

Name: *

Email: *

Verification: *

You need to configure a RoCE network to enable lossless networking for HPE J2000 Flash Enclosure support Which interconnects are required to support this connection? (Select two.)

• A.HPE Virtual Connect SE 100Gb F32 Module for HPE Synergy
• B.Brocade 32Gb Fibre Channel SAN Switch Module for HPE Synergy
• C.HPE Virtual Connect SE 40Gb F8 Module for HPE Synergy
• D.HPE Virtual Connect SE 16Gb FC Module for HPE Synergy
• E.Brocade 16Gb Fibfe Channel SAN Switch Module for HPE Synergy
• F.HPE Virtual Connect SE 32Gb FC Module for HPE Synergy

Comment: *

Name: *

Email: *

Verification: *

Your customer plans to use HPE Primera to boot HPE Synergy compute nodes. They currently have two HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed in the frame. The customer wants to use FC as a storage access protocol What must be done to complete this task?

• A.Add FC upgrade licenses in HPE OneView that will enable FC connectivity for the modules
• B.FC connectivity on the modules should be enabled through the service console by disabling FCoE.
• C.Enable FC primary and secondary boot on the modules through the HPE OneView interface
• D.Enter both modules into a maintenance mode, then enable FC connectivity through CLI

Comment: *

Name: *

Email: *

Verification: *