You plan to configure a Link Aggregation Group (LAG) for two connections within a server profile for a compute node running an ESXI system.
What is required from the VMware side to enable LAG?

• A.Virtual Distributed Switch
• B.vSphere Standard license
• C.Load balancing cluster
• D.Dedicated VMKernel port

Comment: *

Name: *

Email: *

Verification: *

Your customer reports that they cannot deploy HPE Synergy compute nodes using HPE OneView for VMware vCenter Server (HPE OV4VC).
What should you check during troubleshooting process?

• A.If an compute nodes are added to the vCenter Server
• B.If HPE OneView credentials are added in vCenter Server
• C.If the HPE Oneview instance Is integrated with HPE OV4VC.
• D.If vCenter Server is licensed in the HPE Oneview interface

Comment: *

Name: *

Email: *

Verification: *

Your customer plans to deploy VMware vSAN using D3940 Storage Modules.
Which statement about this solution is true?

• A.The 12Gb SAS modules required for D3940 connectivity can only be installed in the first fabric.
• B.To use the storage controller that will access D3940 storage modules, a second CPU must be installed.
• C.All drives in the D3940 storage modules must formulate a single logical drive with RAID5 configured
• D.For VMware vSAN deployment, all drives in the D3940 storage modules must be SSD drives.

Comment: *

Name: *

Email: *

Verification: *

Your customer plans to deploy VMware ESXi 7 0 U2 and they are looking for a hardware platform mat wilt allow them to use up to 24 TB of physical memory.
Which HPE compute system meets this customer's requirements?

• A.HPE Superdome Flex 280
• B.HPE Synergy 480 Gen10 Plus
• C.HPE ProLiant DL380 Gen 10 Plus
• D.HPE ProLiant DL560 Gen10

Comment: *

Name: *

Email: *

Verification: *

Your customer is implementing an HPE Synergy solution based on three frames.
Click each of the ports that can be used to connect satellite modules.

Correct Answer:

Explanation:
The QSFP+ ports (Q1 and Q2) on the HPE Virtual Connect SE 100Gb F32 Module for HPE Synergy can be used to connect satellite modules. These ports are designed to handle high-speed connectivity required for linking additional frames and expanding the Synergy infrastructure.

Comment: *

Name: *

Email: *

Verification: *