A customer needs a shared storage solution for a virtualization platform that will host a database application. The customer is considering an HPE Nimble array.
Which feature would lead you to propose an HPE Nimble AF40 over an HPE 3PAR All Flash array?
Which tool provides a report on the current usage levels and life span of some installed read-intensive flash drives?
You are troubleshooting a HPE ProLiant rack-mount server. You notice that all front-panel status LEDs flash simultaneously.
What does this indicate has occurred on the server?
you are designing a system for a customer that runs an OLTP application. The customer has SAN based storage. They need to accelerate application performance.
Which HPE ProLiant Gen10 feature set will address this customer's needs?
Read the question, and then refer to the exhibit.
display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max- ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type:
Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?
