Refer to the exhibit.

Which statement about the logical interconnect shown is true?

• A.FC uplinks are not supported and will be converted to FCoE or RoCE uplinks.
• B.Additional uplink ports can be added to ETH-Uplink to increase available bandwidth.
• C.For FC uplink sets, an additional uplink from second module should be added for redundancy.
• D.The maximum supported number of the internal networks for logical interconnect is configured.

Comment: *

Name: *

Email: *

Verification: *

Which statement about an HPE OneView server profile is true?

• A.A server profile can be used to configure a local storage controller, but cannot be used to configure SAN-based storage.
• B.A server profile can be created only for HPE BladeSystem, HPE Synergy, and HPE Superdome Flex servers.
• C.A server profile can be used to update firmware and drivers when the operating system on the server is up and running.
• D.A server profile created for a specific server hardware type cannot be moved to a server with a different server hardware type.

Comment: *

Name: *

Email: *

Verification: *

Your customer plans to use HPE OneView to manage a small environment based on HPE ProLiant servers that includes G7 and Gen 10 systems. What should you explain to this customer?

• A.HPE ProLiant Gen 10 servers do not need an HPE OneView license.
• B.HPE Management Agent must he installed for HPE ProLiant Gen 10 servers.
• C.Not all of the features will be available for HPE ProLiant G7 systems.
• D.HPE ProLiant G7 and Gen10 cannot be managed using the same appliance.

Comment: *

Name: *

Email: *

Verification: *

Which statement about a server profile for an Apollo system is true?

• A.Enclosure Group Is automatically selected
• B.Fibre Channel connections can be defined
• C.UEFI optimized is the only available boot mode
• D.Virtual WWNs and MAC addresses can be defined

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Your customer created multiple networks in HPE OneView, but only Eth-1 is available to be used within a server profile. What is a likely cause of this situation?

• A.The other networks are not configured with the required Smart Link parameter.
• B.The other networks have Private Network' selected, which hides them from Compute Modules.
• C.The other networks are configured with a purpose other than General or Management.
• D.The other networks are not added to the Logical Interconnect Group configuration.

Comment: *

Name: *

Email: *

Verification: *