Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: to enable the switch to assign the correct priority and bandwidth to traffic that it transmits to servers
Refer to the exhibit.
You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN) WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be part of the same VXLANs and the desired VNls for the VXLANs. Assume that the network is already configured to permit each ArubaOS-CX switch to reach each other switch's loopback interface.
Is this part of the process for setting up VXLAN to meet the requirements?
Solution: On Switch-1, set 192.168.1.3 as a peer IP address in the VNI 5020 context.
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: Different virtual MAC must be used for IPv4 and IPv6 Active Gateway.
Does this correctly describe Network Analytics Engine (NAE) limitations on ArubaOS-CX switches?
Solution: You can check whether a switch has reached its NAE limitations with the "show capacities-status nae" command.
Does this correctly describe NetEdit's notification capabilities?
Solution: NetEdit notifies admins of errors using Its Internal email server.
