Free HP HPE6-A45 Exam Dumps Questions & Answers

Refer to the exhibits.
Exhibit 1

Exhibit 2

A network administrator applies the ACL to Switch-2, as shown in the exhibit. Device-1, IP address
10.1.10.10/24, attempts to open an HTTP session with host 192.0.2.10 on the Internet. What happens with this attempt?

• A.  Switch-2 filters only the traffic from Device-1 with the ACL, and the session establishes successfully.
• B.  Switch-2 filters both the traffic from Device-1 and the return traffic with the ACL. The return traffic is dropped.
• C.  Switch-2 does not filter any of this traffic with the ACL, and the session establishes successfully
• D.  Switch-2 filters only the return traffic from the Internet with the ACL, and the ACL drops this traffic

What is a reason to implement port security on an AOS-Switch?

• A.  to enhance the security of an 802.1X solution
• B.  to simplify provisioning for devices such as IP phones or printers
• C.  to control management access to the switch CLI based on device, as well as user credentials
• D.  to filter traffic at the edge, based on multiple criteria in the MAC header

An AOS-Switch enforces 802.1X authentication to an Aruba ClearPass server. A user connects but cannot receive network access, even though the ClearPass administrator finds an Access-Accept for the user on this switch. The switch administrator suspects that there is an issue with the dynamic settings returned by ClearPass.
Where should the administrator look for information about these settings?

• A.  in the details for port-access clients
• B.  in the running-config for the interface
• C.  in the detailed RADIUS server statistics
• D.  in the interface statistics

Refer to the exhibit.

Switch-2, Switch-5, and Switch-6 currently have many OSPF routes to Area 1 networks. The network administrator wants to replace these routes with a single aggregated route to 10.1.0.0/16 on each switch.
Where should the administrator specify the 10.1.0.0/16 range?

• A.  in the Switch-1 OSPF Area 0 configuration
• B.  in the Switch-2, Switch-5, and Switch-6 OSPF global configuration
• C.  in the Switch-2 OSPF Area 2 configuration
• D.  in the Switch-1 OSPF Area 1 configuration

The security policy for a company requires that switches use SNMPv3 and accept all read-only SNMPv2c messages. The network administrator enables SNMPv3. Which additional action should the network administrator take to comply with this policy?

• A.  Enable SNMPv3 restricted mode.
• B.  Disable SNMPv1/v2c.
• C.  Enable SNMPv3 only operation.
• D.  Disabled SNMPv3 inform timeouts.