Free HP HPE6-A46 Exam Dumps Questions & Answers

Refer to the exhibit.

A company requires distribution layer switches that can provide Layer 2 and Layer 3 redundancy. The exhibit shows the proposal for these switches. Which change to the proposal will help meet the company's requirements?

• A.  The proposed switches should be replaced with switches such as the Aruba 2930M to support the backplane stacking technology.
• B.  VRRP should be implemented instead of backplane stacking to support the Layer 3 redundancy requirements.
• C.  Link aggregations should be established without LACP to support the Layer 2 redundancy requirements and backplane stacking limitations.
• D.  The proposed switches should be replaced with switches that support VSF to support the required distance between stack members.

The implementation plan for AOS-Switches calls for them to implement port-based tunneled node. The Aruba Mobility Controllers that will support the AOS-Switches run software 8.1. The controllers will also support APs, are managed by Mobility Master, and use clustering.
Which issue with this plan needs to be addressed?

• A.  The switches must use role-based tunneled node to work with clustering controllers.
• B.  The controllers cannot support tunneled node with AOS-Switches when they are managed by the Mobility Master.
• C.  The controllers must have their software updated before they can support the switches.
• D.  The switches cannot connect to controllers that also support APs.

Refer to the exhibit.

The routing switches shown in the exhibit run OSPF on the links between each other. The commander in the Switch-1 VSF fabric goes down. Traffic is disrupted for several seconds.
What should a network administrator do to support a faster failover in a similar situation?

• A.  Configure echo mode BFD on the VLAN that connects Switch-1 and Switch-2.
• B.  Add VRRP on the VLAN between Switch-1 and Switch-2.
• C.  Create a redundant virtual link between Switch-1 and Switch-2.
• D.  Configure graceful restart, or nonstop OSPF, on Switch-1 and Switch-2, with a proper timer.

Refer to the exhibit.

Network administrators set up PIM-DM to route multicast traffic from Server 1 to clients in VLAN 24. The multicasts are not active now, but the administrators want to determine which path the multicasts will take.
What should the administrators check to help them calculate this path?

• A.  What the next hop is for the unicast route that Switch-1 uses to reach 10.2.2.2
• B.  If the Switch-2 DR priority on VLAN 10 is higher than the Switch-3 DR priority on VLAN 11
• C.  If Switch-2 or Switch-3 is listed as an RP in the Switch-1 RP set
• D.  If Switch-2 or Switch-3 has the highest IP address on a VLAN that runs PIM-DM.

The security policy for a company requires that switches use SNMPv3 and accept all read-only SNMPv2c messages. The network administrator enables SNMPv3. Which additional action should the network administrator take to comply with this policy?

• A.  Enable SNMPv3 restricted mode.
• B.  Enable SNMPv3 only operation.
• C.  Disabled SNMPv3 inform timeouts.
• D.  Disable SNMPv1/v2c.