From which solution can ClearPass Policy Manager (CPPM) receive detailed information about client device type OS and status?

• A.ClearPass Guest
• B.ClearPass Access Tracker
• C.ClearPass OnGuard
• D.ClearPass Onboard

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit, which shows the current network topology.

You are deploying a new wireless solution with an Aruba Mobility Master (MM). Aruba Mobility Controllers (MCs). and campus APs (CAPs). The solution will Include a WLAN that uses Tunnel for the forwarding mode and Implements WPA3-Enterprise security What is a guideline for setting up the vlan for wireless devices connected to the WLAN?

• A.Assign the WLAN to a single new VLAN which is dedicated to wireless users
• B.Assign the WLAN to a named VLAN which specified 100-150 as the range of IDs.
• C.Use wireless user roles to assign the devices to different VLANs in the 100-150 range
• D.Use wireless user roles to assign the devices to a range of new vlan IDs.

Comment: *

Name: *

Email: *

Verification: *

You need to deploy an Aruba instant AP where users can physically reach It. What are two recommended options for enhancing security for management access to the AP? (Select two )

• A.Configure WPA3-Enterpnse security on the AP
• B.Place a Tamper Evident Label (TELS) over its console port
• C.Disable the Web Ul.
• D.Disable Its console ports
• E.install a CA-signed certificate

Comment: *

Name: *

Email: *

Verification: *

A company is deploying ArubaOS-CX switches to support 135 employees, which will tunnel client traffic to an Aruba Mobility Controller (MC) for the MC to apply firewall policies and deep packet inspection (DPI).
This MC will be dedicated to receiving traffic from the ArubaOS-CX switches.
What are the licensing requirements for the MC?

• A.one AP license per-switch
• B.one PEF license per-switch. and one WCC license per-switch
• C.one PEF license per-switch
• D.one AP license per-switch. and one PEF license per-switch

Comment: *

Name: *

Email: *

Verification: *

What is one way a noneypot can be used to launch a man-in-the-middle (MITM) attack to wireless clients?

• A.it uses ARP poisoning to disconnect wireless clients from the legitimate wireless network and force clients to connect to the hacker's wireless network instead.
• B.it examines wireless clients' probes and broadcasts the SSlDs in the probes, so that wireless clients will connect to it automatically.
• C.it uses a combination or software and hardware to jam the RF band and prevent the client from connecting to any wireless networks
• D.it runs an NMap scan on the wireless client to And the clients MAC and IP address. The hacker then connects to another network and spoofs those addresses.

Comment: *

Name: *

Email: *

Verification: *